SB-CMS-PIR - ceiling mounted PIR sensor

Subnet ID and Device ID

Device Remark

Change the ID if needed

e.g., you can enable/disable the PIR sensor in HDL-BUS Pro software, you can also send UV switch 253-ON to enable it, or send UV switch 253-OFF to disable it.

Combine logic inputs

Select logic relation

Set logic output

better to set some delay time, e.g., 10s.

Enable the security function of ch1

Assign ch1 to the security

module(3/80) and security

area (1).

Simulate some sensor

value or status.

This is very useful when

to test the new-created

function.

application

Please refer to the 12in1 sensor