Upload
others
View
2
Download
1
Embed Size (px)
Citation preview
www.sainsmart.com
© SainSmart Corporation. All Rights Reserved.
SainSmart Genmitsu CNC Router
User Manual
A. Assembly&Download
Please refer to <SainSmart Genmitsu CNC Router-Assembly Instruction> to assemble the machine and
click on below link to view installation video and download software:
http://wiki.sainsmart.com/index.php/101-60-280
B. Debugging
1. Install the driver CH340SER
2. Double-click on the icon to install
3. Check the USB drive is installed correctly
www.sainsmart.com
© SainSmart Corporation. All Rights Reserved.
4. Open grblControl software to connect the machine
5. Choose the correct port:
Connection succeeded:[CTRL+X] < Grbl 0.9j ['$' for help]
6. Check direction of XYZ axis:
www.sainsmart.com
© SainSmart Corporation. All Rights Reserved.
7. If XYZ works, open the test file
8. How to alignment drill bit’s position
www.sainsmart.com
© SainSmart Corporation. All Rights Reserved.
9. After adjusting the initial position, click “Send” to start working, and during the process you can click
the Mark 2 to stop or start the motor
C. Creat your G code
Part 1 : About ArtCAM
1. Install ArtCAm
www.sainsmart.com
© SainSmart Corporation. All Rights Reserved.
2. Open BMP File
3. Set Model
www.sainsmart.com
© SainSmart Corporation. All Rights Reserved.
www.sainsmart.com
© SainSmart Corporation. All Rights Reserved.
www.sainsmart.com
© SainSmart Corporation. All Rights Reserved.
www.sainsmart.com
© SainSmart Corporation. All Rights Reserved.
www.sainsmart.com
© SainSmart Corporation. All Rights Reserved.
So, with the above example, you can create your own model!
Then use Grblcontrol software to open this NC file and perform engraving in accordance with Part B!
Part 2 : About gcam
1. Open gcam software to design your own pattern.
2. Create a new project, set parameters such as length, width, height and material according to your
material
3. Create a new Sketch
www.sainsmart.com
© SainSmart Corporation. All Rights Reserved.
4. Click Bolt Holes to creat two holes
5. Export G-Code
www.sainsmart.com
© SainSmart Corporation. All Rights Reserved.
6. Choose path export
So, with the above example, you can create your own model!
Then use Grblcontrol software to open this NC file and perform engraving in accordance with Part B!
Note:
The operation of the engraving machine requires the execution of G code. Just type text or pictures will not work.
However, there are many softwares for making G codes, and the software for different designs may be different.
The gcam and ArtCAM provided in this article are just two of them.
Looking forward to your sharing, we will continue to improve, any questions please contact
Email: [email protected]