Upload
trandung
View
238
Download
3
Embed Size (px)
Citation preview
What’s in the box?.....
What do I need to fit it?.....
How to install the VHF on desktop and overhead.....
How to install the VHF flush mount..... Drilling plan.......flush mount.....
INSTALLATION GUIDE
SAILOR 6215/6216 VHF DSC
Thrane & Thrane A/S • [email protected] • www.thrane.com
TT98-128470-THR-F
A A
B B
99-130248
Gasket Flush Mount Bracket (2 pcs.)
Screw M4x45 TORX 20 (4 pcs.)
Connect to LOUD HAILER
(RED isolation on inner connector)
Connect to EXT. SPEAKER
(WHITE isolation on inner connector)
Connect to POWER +
(RED wire)
Connect to POWER -
(BLUE wire)
Square Nut M4x7x2.2 (4 pcs.)
Max wall thickness 26mm
99-130250
Remove material from shaded area only!
89mm
177mm
R2.5mm x 4
Drilling plan.......on desktop and overhead.....
Cable assembly for waterproof installation..... How to install the handmicrophone cradle.....
99-130249
4 x M4 or hole for
self-tapping ø3.9
150mm
53mm
71m
m
196mm
23mm
9mm
Tilting ±20°
1.
2.
3.
4.
Connect the 4 cable connections with rubber vulcanizing tape as shown .....
Power Drill Jigsaw ScrewdriverTORX 20
Drill for M4 orØ3.9 self-tapping
NotNotNotNotNote!e!e!e!e!- Firmly tie back and secure any wires not used in order to
avoid possibility for mutual shorting or shorting to ground!
- To ensure waterproof sealing:If the surface isn’t plane and/or rigid remove the gasket andseal with silicone sealant between the VHF and the surface.
U-MountingBracket
Transceiver Gasket
Flush MountBracket (2 pcs.)
Sun Screen
Fuse6.3x3.2mm (10AT)
User & InstallationManual
Handmicrophone
Cradle
Wheel Knob(2 pcs.)
Screw M4x45TORX 20 (5 pcs.)
Square NutM4x7x2.2 (5 pcs.)
Screw M4x12TORX 20 (3 pcs.)
Screw ø3.9x19TORX 20 (3 pcs.)
Screw M4x12TORX 20 (5 pcs.)
Screw ø3.9x19TORX 20 (5 pcs.)
USER & INSTALLATION MANUAL
SAILOR 6215 VHF DSC
Power CableConnection Cable,1 m
Flush mount template
Remove material from shaded area only!89mm
177mm
R2.5mm x 4
Thrane & Thrane A/S • [email protected] • www.thrane.com
TT98-128470-THR-F
Scale 1:1
How to install the GPS..... input signal.....
Cutout template for flush mounting of the VHF…..
2 x M4 or hole for
self-tapping ø3.9
34.6mm
46.8mm
28.5mm
Scale 1:1
HandsetSpeaker Microphone
Control
SAILOR 6208
6215/16
(DSC Radio)GPS in (NMEA 0183)
CableService
Loud Hailer (4 ohm)Speaker (8 ohm)
External
AC
C. P
ort
Pow
er
Handset OptionControl Speaker Microphone
Connection Box
SAILOR 6209Accessory
SAILOR 6204/05
Speaker MicrophoneControl
SAILOR 6204/05
Speaker MicrophoneControl
SAILOR 6204/05SAILOR 6201
SAILOR 6201
Connection Box
99-129890-A
VHFHandmicrophone
SAILOR 6202
OR
12V DC
110/220V AC
GP
S
GPS,
N163S
CALL
Hi/Lo
MENU
16/9
VOL
SQ
(HH størrelse)
DISPLAY
Push =
Enter
CALL
Hi/Lo
MENU
16/9
VOL
SQ
(HH størrelse)
DISPLAY
Push =
Enter
CALL
Hi/Lo
MENU
16/9
VOL
SQ
(HH størrelse)
DISPLAY
Push =
Enter
AerialRX/TX
12V Battery N42024V DC
System Configuration..... Example.....
IMPIMPIMPIMPIMPORORORORORTTTTTANANANANANT!T!T!T!T!If this template was printed from an electronicfile or copied, scaling (1:1) may not be correct.Consequently do not attempt to use a printedor copied template without prior checking ofdimensions.
NotNotNotNotNote!e!e!e!e!The SAILOR 6204/05 Control Speaker Microphone not yet available.
IMPIMPIMPIMPIMPORORORORORTTTTTANANANANANT!T!T!T!T!If this template was printed from an electronicfile or copied, scaling (1:1) may not be correct.Consequently do not attempt to use a printedor copied template without prior checking ofdimensions.
Mounting template for handmicrophone cradle.....
Brown, Pin 1, NMEA in +
Blue, Pin 2, NMEA in -
For waterproof installation use
rubber vulcanizing tape
GPS Cable (NMEA 0183)
99-130267IMPIMPIMPIMPIMPORORORORORTTTTTANANANANANT!T!T!T!T!Please note that the unused wires do not short-circuit.
Cable Connections.....
Pin assignments
Front View
Wire colorPin
Brown1
Blue2
White3
Green4
Yellow5
Grey6
Pink7
Red8
1
29
8
7
6 10 3
45
Black9
10 Orange - SCREEN (Drain)
NMEA in+
NMEA in-
NMEA out+
NMEA out-
Mike 2 / Line in
EAR 2 / Line ou
Hook_PTT
Bat_SW Supply Volt when on
Internal GND = - Battery
Internal GND = - Battery
Description