S19 – Drill Rig Inspection Checklist H&SM&I10

S19 – Drill Rig & Compressor Inspection Checklist H&SM&I10 - 1 / 1 Produced in association with The Institute of Quarrying

Issue 1 : Revision 1 - September 2012 © QMJ Publishing Ltd

Health & Safety Risk

Management System

Site ........................................................................................................... Machine ............................................................................................ Date .........................

Item inspected M Tu W Th F S Su Action required Date completed

Before start up ✓ = OK 7 = defect

Check oil and water levels (hydraulic oil after start up) O O O O O O O ...................................... ...............................

Complete a walk round inspection O O O O O O O ...................................... ...............................

Are all high pressure connections chained? O O O O O O O ...................................... ...............................

After start up (before moving off)

Check instruments are reading correctly O O O O O O O ...................................... ...............................

Check the lights are OK O O O O O O O ...................................... ...............................

Check the operation of the air conditioning/filtration (where applicable) O O O O O O O ...................................... ...............................

Prior to drilling

Is suitable crest protection or fall arrestment equipment available? O O O O O O O 7 = stop and seek advice ...............................

Are holes marked and have you a suitable drill log sheet? O O O O O O O 7 = stop and seek advice ...............................

During Operation

Inspect for oil, water, or fuel leaks and unusual smells or noises O O O O O O O ...................................... ...............................

Grease – in accordance with manufacturer’s instructions O O O O O O O ...................................... ...............................

Are the holes properly sealed by the rubber skirt? O O O O O O O ...................................... ...............................

Is the dust extraction equipment fully operational? O O O O O O O ...................................... ...............................

At end of shift

Drain the air tanks O O O O O O O ...................................... ...............................

General

Are there any obvious signs of cracks, overhangs on/behind the face? O O O O O O O 7 = stop and seek advice ...............................

Is the brake operational? O O O O O O O ...................................... ...............................

Is your shelter up wind of the rig? O O O O O O O ...................................... ...............................

Is the compressor on level ground? O O O O O O O ...................................... ...............................

Seat and seat belt condition (where applicable) O O O O O O O 7 = stop and seek advice ...............................

Clean the cab (vacuum etc) O O O O O O O ...................................... ...............................

Signature of person carrying out inspection ............................................................................... Countersignature of management ....................................................................................

Da

ily

We

ek

ly