Embed Size (px)
Citation preview
Rosie® Scan Bladder Scanner Assembly Guide
Rosie Technical Support 1-800-841-1109 | [email protected]
Page 1
1. Gather parts needed for assembly.
Rosie® Scan Bladder Scanner Assembly Guide
Rosie Technical Support 1-800-841-1109 | [email protected]
Page 2
2. Connect pole to base:
Lay the pole horizonally, turn base on its side and insert pole into opening.
While holding the base in place, insert the bolt with washer in the bolt hole from the bottom of the base, and tighten the bolt.
Rosie® Scan Bladder Scanner Assembly Guide
Rosie Technical Support 1-800-841-1109 | [email protected]
Page 3
3. Stand pole upright:
Tighten the bolt into the pole until the pole is pulled into the base. Now stand the pole upright.
Rosie® Scan Bladder Scanner Assembly Guide
Rosie Technical Support 1-800-841-1109 | [email protected]
Page 4
4. Tighten tray to mount:
Tilt the Tray to a flat position.
Turn the black lever until tight
If the tray is not tight enough, loosen the black lever, and use a half inch wrench on the opposite side of the mount. Tighten the half inch bolt, and then turn the black handle until tray is tight in the upright position.
Align and use mounting screws in positions shown at right.
Rosie® Scan Bladder Scanner Assembly Guide
Rosie Technical Support 1-800-841-1109 | [email protected]
Page 5
Your assembled RosieScan Bladder Scanner should look like the one shown.
If you need additional assistance, please contact Rosie Technical Support at 1-800-841-1109.
