Front

RHLH

(x) mm

Equal =

Equal =

Equal = Equal =

(x) mm

End Support Distance and Bar length

27-0846Rear RH

27-0844Front RH

27-0847Rear LH

27-0845Front LH

If speci�ed to do so, �t the supplied Pad adaptors to the feet of each End Support in the location indicated. The numbers shown to the left correspond to the correct location of the feet pads. The numbers are moluded in the underside of each part. The numbers shown above in the vehicle table correspond to the correct adaptor block to be inserted in the foot pad (if required)Refer to step 1 of the �tting instructions for more information.

Pad Adaptor Requirement(shown from the underside)

Place Strap bolt facing up

Place Strap bolt facing down

The strap bolt

Strap Bolt Position

The strap bolt position is important to the correct set-up of your end supports. Refer to the vehicle speci�c imageand follow the instructions for correct installation position.

End suport distance from mid-pillar Distances for setting out your racks arede�ned from the mid pillar of thevehicle. Both forward and rearwardmeasurements are given to the centre ofthe straps.Take care to set your racks outas shown to ensure your racks �t andperform as they have been design to.Right & Left hand sides of the vehicle arede�ned as you would be when sitting inthe vehicle

Front

Mid pillar

A B00mm 00mm

Your roof rack is at its strongest and looks its best when the cross bar is centred equally within the end supports. Measure the distance between end supports on the underside of the bar. Slide the end supports until the distance between them is correct and the cross bar is centred. Lock the bars in place using the locking lever and proceed to the next step.

Installation Guidefollow the vehicle specific instructions to set up your racks correctly

Strap Bolt Position

End Support Distanceand Bar length (x) Pad Apaptors

End Suport Distance from Mid Pillar

Concealed

Extended

Make Model Door/Body Series Released Finished

Place strap bolt facing up N/AN/A

N/AN/A

Mitsubishi Triton 4D Ute ML 07/2006 07/2009 Front 875mmRear 865mm

Front 200mmRear 500mm

Strap No. / Location

Front

7193 7194

Rola Roof Rack Warranty Registration CardTo ensure smooth handling of any warranty claims, please complete the form below and send to the address indicated overleaf.

Name

Address

Suburb

Dealer/Reseller

Suburb

Vehicle Make

Model/Year

Product/Part Numbers

Customer Details

Store Details

Vehicle/Product Details

Please tick if you do not wish to receive product information or marketing offersfrom Rola.

Place strap bolt facing up N/AN/A

N/AN/A

Mitsubishi Triton 4D Ute MN 08/2009 12/2014 Front 875mmRear 865mm

Front 200mmRear 500mm

Front

7193 7194

Mitsubishi Triton 4D Ute MQ 01/2015 OnPlace strap bolt facing up Front

7193 7194

N/AN/A

N/AN/A

Front 905mmRear 860mm

Front 200mmRear 500mm

Rola Roof Racks 5 Year Warranty

Rack System: (“Rola Roof Rack”). The Rola Roof Rack incorporates three components:

Cross Bars

End Supports

Fit Kit

VEHICLE COMPATIBILITY & WARRANTY

For more information visit www.rola.com.au

Cequent warrants that, subject to the exclusions and limitations below, the Rola Roof Rack will be free from

defects in materials and workmanship for a period of 5 years commencing on the date of sale by the

authorised Rola stockist to the original purchaser of the entire Rola Roof Rack, including the End Support, Fit

Kit and Cross Bars.

If a defect appears in the Rola Roof Rack before the end of the warranty period and Cequent finds the Rola

Roof Rack to be defective in materials or workmanship, Cequent will, in its sole discretion, either:

1. Repair the Rola Roof Rack or the defective component of the Rola Roof Rack free of charge;

2. Replace the Rola Roof Rack or the defective component of the Rola Roof Rack; or

3. Refund the purchase price of the Rola Roof Rack to the original purchaser.

Cequent reserves the right to change the design, specifications or composition of the Rola Roof Rack without

notice and without liability.

Cequent reserves the right to replace defective products or components with products or components of

similar quality, grade and composition, where an identical product or component is not available.

Goods presented for repair may be replaced by refurbished goods of the same type rather than being repaired.

Refurbished parts may be used to repair the goods.

The 5 year warranty only applies where the entire Rola Roof Rack is purchased in one transaction and is

installed and used together.

The 5 year warranty does not apply where:

1. The Rola Roof Rack is not installed in compliance with the fitting instructions provided;

2. The Rola Roof Rack is not used as intended or designed;

3. Any part of the Rola Roof Rack, such as the End Supports, Fit Kits, or Cross Bars, is used with

other products or components notintended to be used in conjunction with the modular Rola Roof

Rack system;

4. The Rola Roof Rack has been on-sold or assigned by the original purchaser;

5. The Rola Roof Rack has been modified or repaired by someone other than Cequent or an authorised

Rola stockist;

6. Cequent cannot establish any fault in the Rola Roof Rack after testing;

7. The Rola Roof Rack has been subject to abnormal conditions, including fire, water, humidity,

pressure, stress or similar;

8. The defect in the Rola Roof Rack has arisen due to abuse, misuse, neglect or accident;

9. The defect in the Rola Roof Rack has arisen due to the unlawful or unusual operation of the vehicle

to which it is fitted;

10. The defect in the Rola Roof Rack has arisen due to the purchaser’s failure to properly assemble,

install, fit, maintain or use the Rola Roof Rack in accordance with the specifications and instructions

provided by Cequent.

For safety and use instructions, please refer to any General or Specific Fitting Instructions and Use & Care

Instructions enclosed with the Rola Roof Rack or on our website at www.rola.com.au.

This warranty does not extend to fair wear and tear. Warranty claims can be made by contacting Cequent

directly using the details below. A warranty claim must be accompanied by proof of purchase (such as receipt)

and details of the alleged defect.

It is the purchaser’s responsibility to arrange and pay for any warranty claims, including the shipment of goods

to Cequent for inspection. The purchaser may seek reimbursement from Cequent for the costs of such

activities, providing Cequent notifies the purchaser in writing that a warranty claim is justified. Any such

claims must be made in writing via post or email.

The benefits of this warranty are in addition to any rights and remedies imposed by Australian State and

Federal legislation that cannot be excluded. Nothing in this warranty is to be interpreted as excluding,

restricting or modifying any State or Federal legislation applicable to the supply of goods and services which

cannot be so excluded, restricted or modified.

Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are

entitled to a replacement or refund for a major failure and for compensation for any other reasonably

foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to

be of acceptable quality and the failure does not amount to a major failure. Cequent makes no express

warranties or representations other than set out in this warranty.

Vehicle Compatibility GuideThis Fit Kit is compatible with the following vehicles.

Make Model Year

Mitsubishi Triton 4D Ute ML 07/2006- 07/09

IF YOUR VEHICLE IS NOT LISTED HERE

We are constantly adding vehicles to these kits, If the set-up instructions for your vehicle do not

appear in this guide, go to www.rola.com.au/fitkits/vcs013.pdf for your set up information

The repair or replacement of Rola Roof Racks or part there of, or a refund of the purchase price of the Rola Roof Rack, is the absolute limit of Cequent’s liability under this express warranty.Cequent, a division of TriMas Corporation Pty Ltd. 49 Pacific Drive, Keysborough, VIC, 3173. Phone 1800 812 017. www.rola.com.au. For detailed warranty information visit us online.

Mitsubishi Triton 4D Ute MN 08/2009- 12/14

Mitsubishi Triton 4D Ute MQ 01/2015- on

VFSO13 Revision D

Please complete the Warranty form on the reverse side and post to:

PO BOX 4050Dandenong South

VIC 3164Australia

ABN 60 004 546 543