1 Canadantario, Oississauga, May WFoxTerry 5855 28262 NCCharlotte, Drive, Taylor David 10200

MODEL #

CONDITION

SERIAL #

Electrolux, Frigidaire, CrosleyBRAND

05.19.14RF1205 Noisy Flex Tray Fresh Food Ice Maker Fan

SERVICE FLASH

E23BC78EI23BC35EI23BC56EI23BC65EI27BS26EI28BS56EI28BS65

EW23BC71EW28BS71EW28BS85FGHB2844FGHB2846FGHB2869FGHB2878

FGHF2344FGHF2346FGHF2369FGHF2378FGUB2642FPHB2899FPHF2399

LGHB2869LGUB2642CFD26WCFD28W

4A106xxxxx – 4A410xxxxx

Fresh Food Ice Maker fan makes intermittent, buzzing noise. Over time, the fan may stop completely and the ice maker will stop producing ice.

Ice accumulation in front of the fan causes intermittent buzzing noise. Ice accumulation results from incomplete defrost and/or defrost water dripping in front of the evaporator housing. See Figure 1.

Figure 1SOLUTION Fresh Food Ice Maker fan noise and potential subsequent failure to operate is caused by ice accumulation in front of the fan. Solution focuses on elimination of ice build-up and improved defrost performance.

To eliminate and prevent ice build-up in front of the fan:• Clear the area of ice and frost. Use a hair dryer to

dry excess moisture. DO NOT use a steamer.• Remove mastic pad shown in Figure 2. This pad

can be pulled apart and removed. No tools are required.

• Ensure that the refrigerant lines are pushed all the way against the liner and that any water dripping during defrost will drop into the evaporator housing and not in front of it. See Figure 3.

• Install Seal Kit 5303918650.

2 Canadantario, Oississauga, May WFoxTerry 5855 28262 NCCharlotte, Drive, Taylor David 10200

05.19.14RF1205 Noisy Flex Tray Fresh Food Ice Maker Fan

SERVICE FLASH

SOLUTION CONT’D To ensure optimal defrost performance:• Diagnose and, if necessary, repair the

defrost system.• Ensure wires are properly routed. The

wires should be routed so that after the air handler is reinstalled they are not pinched between the refrigerant lines or pinched between the lines and the Evaporator Housing.

Figure 2

Remove Black Mastic PadAs with all repairs within the Flex Tray Ice Maker air handler, inspect and, if necessary, replace all gaskets (Kit 5303918650).

PART(S) NEEDED Flex Tray Seal Kit - 5303918650Kit Contains: 242124801242124802242095402A242095403A242095404242095405A242095407242095408A2421460015303950289A00338301

- Gasket- Gasket- Gasket- Evap Housing (2)- Gasket- Evap Housing- Gasket- Evap Housing- Gasket- Evap Housing- Gasket- Gasket- Evap Housing- Gasket, Housing Funnel- Instruction Sheet- Foam Blocks (2)

This is NOT a policy service flash. Claims related to this repair should be filed normally and will ONLY be covered during the warranty time period.

CLAIM FILING

Figure 3

Push Refrigerant Lines against Liner