2
Minh C. Hoang 2511 Marline Lane 256-337- 1329 Huntsville, Alabama 35803 [email protected] EDUCATION Bachelor of Science in Electrical Engineering May 2016 University of Alabama in Huntsville GPA 3.69/4.0 RELEVANT COURSEWORK Introduction to Electronic Analysis and Design - analyze and design electronic circuits, there was a project about design a simple BJT amplifier circuit for receiving the over-the-air HDTV signals. Electrical Circuit Analysis I &II - build an understanding on how to analyze a circuit with currents, resistors, capacitors, and inductors. And also about how to find the power that delivered and absorbed in a circuit. ACADEMIC PROJECTS Laser Light Show Fall 2013 Soldered the resistors, capacitors and inductors with other elements to the layout circuit board. This project also had 2 motors, 1 small speaker and 3 small mirrors mounted on the motors and speaker. And the purpose was to show different shape of laser and with the vibrating from the speaker when turned on music. Antenna circuit for TV signal reception and amplification Cascade two stage BJT circuit for high frequency signal processing Spring 2014 Control system of a spray-paint robot Design a function for control system of an automatic spray paint Summer 2014

Resume2

Embed Size (px)

Citation preview

Page 1: Resume2

Minh C. Hoang

2511 Marline Lane 256-337-1329

Huntsville, Alabama 35803 [email protected]

EDUCATION

Bachelor of Science in Electrical Engineering May 2016University of Alabama in Huntsville GPA 3.69/4.0

RELEVANT COURSEWORK

Introduction to Electronic Analysis and Design - analyze and design electronic circuits, there was a project about design a simple BJT amplifier circuit for receiving the over-the-air HDTV signals.

Electrical Circuit Analysis I &II - build an understanding on how to analyze a circuit with currents, resistors, capacitors, and inductors. And also about how to find the power that delivered and absorbed in a circuit.

ACADEMIC PROJECTS

Laser Light Show Fall 2013

Soldered the resistors, capacitors and inductors with other elements to the layout circuit board. This project also had 2 motors, 1 small speaker and 3 small mirrors mounted on the motors and speaker. And the purpose was to show different shape of laser and with the vibrating from the speaker when turned on music.

Antenna circuit for TV signal reception and amplification

Cascade two stage BJT circuit for high frequency signal processing Spring 2014

Control system of a spray-paint robot

Design a function for control system of an automatic spray paint Summer 2014

Music processing using Matlab Fall 2014

TECHNICAL SKILLS

Multisim Quartus II Matlab

HONORS AND AFFILATIONS

UAH Transfer Scholarship 2013-2015 National Honor Society of Leadership and Success 2014-Present Phi Theta Kappa 2012-Present Eta Kappa Nu Spring 2015-Present

Page 2: Resume2

Tau Beta Pi Spring 2015-Present UAH Engineering Dean's List 2014-2015

ACTIVITIES

Volunteer at Manna House Spring 2015 Volunteer at Friend Of The Lepers in Huntsville Spring 2015 Blood Donate September 2015