2x

2x

2x

2x

2x

Input 1 Input 2

Digital Audio Out

Optical HDMI Ethernet

12V DC5A max

USB5V DC 500mA

Coaxial

13V/18VDC350A maxCombined

TV aerial

Replacing your iQ3Let’s get you going! Follow these simple steps to install your new iQ3.

1 Connect your new iQ3

2 Pair your Bluetooth remote

4 Connect your iQ3 to the internet

5 Tune your free-to-air channels

– Remove the cables from the back of your current iQ3, and connect them into the same sockets on your new iQ3, one by one.

– Replace your current Power Pack and Lead with the new Power Pack and Lead included in this kit E .

– Once you’re connected, use your TV remote to select the HDMI source you’ve connected to.

To get the most out of your iQ3 features, connect your Ethernet cable from your internet access point to the back of the iQ3, or if your modem isn’t within reach of your iQ3, connect to WiFi by following these steps:

To receive your free-to-air channels* off your TV aerial, check you’ve connected your iQ3 to your aerial wall plate, then:

Need a helping hand? For iQ3 tips and tricks, view the Help videos in the ‘Using iQ3’ section of your Home menu. For troubleshooting or support, go to the ‘Help’ section in your Settings menu or visit foxtel.com.au/support

Select Home on your iQ3 remote, then arrow right and select Settings.

Select Home, arrow right and select Settings.

Select WiFi.

Select Quick Scan.

Select Internet Connection.

Select Terrestrial Channels from Settings.

Select your network.

Select Begin Scan.

Enter your WiFi password, select Done and you will be advised once connected.

Once scan is complete select View TV Guide.

Remote and Batteries

iQ3 Box TV Aerial Cable and Adapter

Foxtel Cables Ethernet Cable(optional, see step 4)

To TV aerialwall plate (optional)

To Foxtelwall plate

To TV To internet access point(optional, see step 4)

To power point

HDMI CablePower Pack and Lead

FOX

092

9 0

4/17

DIY

iQ

3 S

AT

* Free-to-air channels will vary based on location. Not all channels are available in all areas.

6 Return your old Set Top Box

Press and hold the Home button on the iQ3 remote until the light at the top of your remote stops flashing and remains blue, then you’re all set!

Once the standby button on your iQ3 has turned blue, bring your remote to the front of your box. Brush your hand slowly across the front of your iQ3 until the front panel lights up.

To reset your existing remote, press and hold the button located underneath the battery cover.

Returning your equipment is easy. All you need to do is refer to the document enclosed in this kit that outlines your return options.

Included in this kit, you should have:

– iQ3 Box

– Power Pack and Lead

– A document detailing how to return your old iQ3 Box

You’ll also need these items from your current Foxtel setup:

3 Call 1300 732 681 to activate your iQ3

Don’t be a maverick – make sure your TV and existing iQ3 are turned off at the wall.

FOX0929_DIY_iQ3_SAT_C3.indd 1 19/04/2017 4:03 PM