23/07/12 Chilton Repair Content - Print

1/2content.chiltonsonline.com/Repair/PrintView.aspx

Remote Function Actuator (RFA) Module

SECTION 419-10: Multifunction Electronic Modules

2011 Fiesta Workshop Manual

REMOVAL AND INSTALLATION

Procedure revision date: 01/28/2011

REMOTE FUNCTION ACTUATOR (RFA) MODULE

Special Tool(s)

VehicleCommunicationModule (VCM)and Integrated

DiagnosticSystem (IDS)software withappropriatehardware, or

equivalent scantool

Click to Enlarge

Item Part Number Description

1 W503922 Remote Function Actuator (RFA) bracket bolt (2 required)

2 — RFA bracket

3 — RFA module J-nut (2 required)

23/07/12 Chilton Repair Content - Print

2/2content.chiltonsonline.com/Repair/PrintView.aspx

4 19G481 RFA module

5 — RFA module electrical connectors (part of 14A005)

6 — RFA module screw (2 required)

Removal and Installation

1. NOTE: The IA keys need to be programmed into the new RFAmodule during ignition off. For additional information, refer to KeyProgramming Using Diagnostic Equipment in Anti-Theft — PassiveAnti-Theft System (PATS). After the IA keys have been programmedinto the new RFA module, the ignition must be turned to the ONmode in order to reset the parameters in the new RFA module andthe PCM. For additional information, refer to Passive Anti-TheftSystem (PATS) Parameter Reset in Anti-Theft — Passive Anti-TheftSystem (PATS).

Remove the passenger seat. For additional information, refer toSeating.

2. Disconnect the 5 RFA module electrical connectors.

3. Remove the 2 bolts and the RFA module and bracket assembly.

To install, tighten to 10 Nm (89 lb-in).

4. To install, reverse the removal procedure.

Program the IA keys into the new RFA module. For additionalinformation, refer to Key Programming Using DiagnosticEquipment in Anti-Theft — Passive Anti-Theft System(PATS).

Carry out a Passive Anti-Theft System (PATS) parameterreset. For additional information, refer to Passive Anti-TheftSystem (PATS) Parameter Reset in Anti-Theft — PassiveAnti-Theft System (PATS).