MODULE DESCRIPTION

www.ampio.com.pl

Relay module MPR-2p

ver 1.1, 14.02.2017Copyright © 2016 Automatyka-Control. All rights reserved.

PurposeModule MPR-2p is a component of the Ampio Smart Home system. It has two relay outputs, two inputs shorted to ground, and an option to connect up to six 1-Wire sensors (e.g. temperature, humidity). The module has an LED indicator, which signals communication over CAN-Bus: one regular flash every 1 sec. - CAN-Bus communication in order two regular flashes every 1 sec. - module is not receiving information from other iDom modules three regular flashes every 1 sec. - module cannot send information to CAN-Bus

Examples of application: lighting control propulsion systems control any devices with a maximum power not exceeding 230V, whose energy consumption does not exceed 6A. connecting digital sensors (e.g. temperature DS18B20) compatible with the Dallas 1-Wire bus

Module steering is done via CAN-Bus. Required voltage for the module is 12V DC.

The module is equipped in two inputs, two outputs, and a digital sensor One Wire (DS18B20) input. Inputs can be used to, for example, connect standard light switches. Two device outputs enable independent steering of two receivers. Each output is and independent relay contact, so it is possible to connect them in such a way that one section controls 230V AC voltage, and the other one 12V DC, etc.

Six Dallas DS18B20 temperature sensors can be connected to the module. Temperature measurement results can be used freely to perform certain tasks, e.g. to close the blinds, switch pumps, or valves on/off, to present info on sensor switches with screens, or to preview in native applications. Module programming is done through a special

as through the iDomKonfigurator programme. Thanks to the programme, the ways in which modules should react to inputs and other information from the CAN bus can be configured.

Technical data: Module voltage supply 12V DCEnergy consumption 30 mANumber of relay outputs 2Output current-carrying capacity (OUT1...2) 6AMaximum switchable voltage 230VNumber of module inputs 21-Wire connector yes, up to 6 sensorsDimensions: width 47mm height 47mm depth 20mm

* - Given value refers to closed-circuit current - without controlling relays

www.ampio.com.pl

Relay module MPR-2p

ver 1.1, 14.02.2017Copyright © 2016 Automatyka-Control. All rights reserved.

47

47

20

21

15

Dimensions in mm

STATUSAmpio

MPR-2p2 x OUTPUT, 2 x 6A

OUT2OUT1

CANLOW

CANHI

+12V DC

GND+

IN2

1-Wire

IN1

GND

Scale 1:1