Recording Vocals 3

8/12/2019 Recording Vocals 3

1/4

Recording Vocals (pt III)

In part III we share some secrets on the art of comping

If you've read the previous two parts to this feature you should have all your hardware in place, and your vocalistwill be suitably chilled-out and raring to give it some into the microphone.

This time we'll look at how to construct a definitive lead vocal from several takes, as well as double tracking andbacking vocals. So let's hit 'record' and roll through the song.

Different singers and producers will approach recording a vocal in different ways. Vocals can be sung a wholesong at a time, a section (verse or chorus) at a time, a line at a time, a word at a time or even a syllable at a timea method that allegedly came as something of a surprise to the Pet Shop Boys when working with DustySpringfield.

Ultimately the method used has to be what the singer is most comfortable with or is prepared to do, whether thatmeans concentrating on one line at a time, singing it over till it's exactly right and only then moving onto the nextone, or perhaps singing the whole song in one take and going back to repair any duff phrases or words bydropping in.

Any method or combination of methods is valid if it gets the job done. A situation where there is only one track leftto record the vocal on is always going to be more stressful than having several tracks available.

If you only have one track to work with, getting drop-ins accurate is essential and you have to hope that anydropped-in vocals are going to be an improvement on the ones you are erasing, because you can't go back to it ifthey aren't.

With more than one track available more options open up; notably the fact that you can keep a vocal on one track

and record another one on a different track.

My own preference is, if possible, to work across three separate tape tracks while keeping another free to bouncethe best bits of each across, to create a vocal that is hopefully greater than the sum of its parts.

Another personal preference, if the singer is willing, is to record a full pass of the song each time. This gives thesinger a chance to warm up and get into the feel, momentum and dynamics of a song, which ought to producemore of a performance than would be achieved by constantly stopping and starting the tape.

However, this isn't an approach that will work every time. Some singers will prefer other methods and their needsare paramount there is nothing to be gained by coercing people into doing things that don't feel right for them.

In a situation where you are recording a vocal across three tracks, it's possible that a definitive vocal might becaptured solely on one of them, negating the need to make a 'comped' vocal.

However, if bits of several of the tracks are to be used, a consistency in sound from track to track is prettyessential as level and timbral changes will make it hard to match the sections up. To achieve this, keep thevocalist the same distance from the mic for all the takes, (gaffa tape on the floor to mark the position will do thetrick), and once you have settled on a headphone mix, amount of compression and EQ, stick to it.

So let's go through the method of working with three tracks and constructing a composite vocal. We'll be referingmainly to working with a conventional multitrack recorder and mixing desk here, but anyone using a computer-based system will still find the following procedure of use.

Recording itIf you're lucky, the first pass a singer takes at a vocal might just be the perfect performance. It does happen the

Page 1 of 4intermusic.com

9/17/01http://intermusic.com/print.asp?ReviewId=1393&ArticleTable=Features&FeatureType=TUT...


2/4

adrenaline kicks in, the singer puts in the performance of their life and couldn't possibly do it better. It's usuallyfairly obvious when this happens, and a decision has to be made whether to go for a second take on a differenttrack anyway.

If you do go for a second take, it will soon become apparent whether or not it's going to top the first. But the bestperformance doesn't often happen on the first take. It's more common for a singer to have several attempts at asong, improving with each take. In this case, take track 1 out of record-ready and record another performance ontrack 2.

With some singers there is a palpable sense of relief at having got that first vocal in the can. It allows them to relaxa bit and the second performance benefits from this. Another thing to note is that singers do need to warm up,both in terms of of the voice getting physically stronger, and of the performance becoming stronger throughrepetition. So it is likely that track 2 will be an improvement on track 1.

To record a third performance, take track 2 out of record-ready, mute its playback channel, rewind and go foranother take, this time on track 3.

At some point in this process the singer may want to hear some or all of the performances back. That's fine it willgive them a chance to hear what they have been doing and assess how they can improve on it, as well as givingthem a break, although this has to be balanced against losing the natural flow and momentum of the session.

Personally, as engineer or producer, I'd rather have a singer build up a head of steam and do a few takes in quicksuccession before coming in to listen, but each session and singer is different and working methods must be

adapted to the prevailing circumstances.

If the performances are getting better with each take and the singer is still game for it, then the next step is torecord a fourth performance or take. Note the use of the word 'take' and not 'track' at this stage it is possible tomove onto a fresh track and record another vocal, but having different vocal performances spread over, say, four,five or six tracks makes things a bit unwieldy when it comes to listening back and choosing the best bits.

If occasion or the singer demands it then more tracks can be used, but working on three tape tracks only is amuch simpler and much more workable proposition.

So, sticking to working with three tracks only, take number 4 will usually be recorded over take 1 on track 1,assuming that the singer agrees that the first take was poor compared with the last one and that the performancesare generally improving. So here we go, with playback from tracks 2 and 3 muted and recording on track 1 again.

At this point it's worth noting that a tracksheet, pencil, rubber and notepad are essential for keeping track ofeverything, especially a note of which take is the best of the three at any point.

From this point on, as long as the singer's performance continues to improve, the process can continue with afresh vocal being recorded over the worst of the three already on tape until the performances reach a peak, or thesinger decides they've done enough. Use your judgement to tell you when you've got enough good vocals.

At some point it is important to draw a line under the proceedings, as vocals will not keep improving indefinitelyand voices get tired.

When there are three good performances recorded, it's time to assess what you've got. It's just possible that oneof them might be the definitive performance in itself, but if that's not the case, bits from all three performances canbe combined to create the best possible comped vocal.

AppraisalAs an aid to appraising the recorded vocal performances, take a large sheet of paper and make up a chart withthe lyrics line-by- line down the left hand side of the page, and three vertical columns on the right.

Next, sit down with the singer, listen back to each performance, give each vocal line a score out of three and markit in the vertical column for that track ticks or crosses are a good visual indicator. It's also a good idea to jot downquick notes of odd words that may spoil an otherwise good line, or that stand out in an otherwise crap line.

After playing back all three tracks of vocals you will have a fairly good idea of which lines should make up the finaledited version of the lead vocal. It may be the case that one track stands out from the others, with most linesscoring threes, and that line should form the basis of the composite track, with any imperfect lines or wordsreplaced by good ones from the other two tracks.




3/4

There are obviously several routes through the song and the important thing is to run through the song a fewtimes and, by switching between tracks with the channel mute buttons, try out the various permutations to seewhich sounds best.

You may find that you have to switch tracks in the middle of a line, but eventually the best-sounding route throughthe song will be found. Mark it on the chart with a highlighter pen, taking care to note the exact position in eachline where the tracks should be switched.

But what if you find yourself with three good vocal takes, all with a real clunker of a word, or a line that is equallybad on all three tracks? The obvious solution is to get the singer back in the vocal booth and attempt to drop in agood version of the offending word or line.

The same method as before can employed, utilising all three tracks if required. Alternatively and this only possiblewhere the same word or line appears twice in the same song the word or line can be sampled and dropped inwhere needed.

Anyone working on a digital system with good editing facilities will have no trouble moving the odd word or linearound, but for anyone using tape sync'd to a sequencer, the easiest way to sample a vocal line and move it toanother part of the song (without lots of editing of start times and so on) is to initiate sampling using a MIDI note atthe start of the bar, and sample a whole block of vocals.

Moving the line to another position in the song is simply a matter of moving the same MIDI note to the bar where

the new line should start, and using it to trigger the sample.

BouncingHaving decided which lines will make up the best possible comped vocal, it can now be put together, anddepending on the medium you are working with, the deed can be done in different ways. Anyone with a computer-based digital system will have their own method of editing a vocal together; anyone using a digital or analoguetape-based system can bounce bits from the three tracks across to another track.

With analogue tape, any track bouncing is going to slightly degrade the sound quality. This may be unacceptableto some, but the advantage is that once the composite track is recorded the original vocal tracks can be erased,effectively freeing up two tracks. If there is no shortage of tracks, then the composite vocal can be constructed atmixdown by switching between the three no bouncing required.

This is straightforward if your console offers fader and mute automation. Otherwise it's a lot of work, but if that'sthe preferred method it is still useful to make up a composite vocal on one track to be used as the reference vocal

for additional overdubs.

To make the comp when working with a multitrack tape machine, the three recorded vocal tracks (source tracks)should be bought back through three adjacent desk channels (adjacent for ease of switching) and routed to aclean track (destination track).

Let's call the destination track '6' for sake of argument (remember never to bounce to an adjacent track on ananalogue machine). The three source tracks should not be routed to the main L/R mix, but the destination trackshould be, as this is the one we need to monitor.

With the destination track in record-ready, set the tape running and switch between the three source tracks byusing the desk's channel mute buttons and following the previously drawn-up chart. If the three vocal tracks havebeen recorded consistently they should all be set at the same level, but it may be that some minor leveladjustments have to be made for the odd word or phrase, and a piece of masking tape fixed alongside the

channel fader is useful for making the various level changes.

Sometimes a little EQ may be needed to even things up on one of the tracks where the singer's timbre haschanged, and if you decide that a little overall EQ or compression should be added to the composite track while itis being committed to tape, then outboard processors can be patched in on the group insert.

Once you're well-versed with your fader moves and channel switchings, roll the tape and record onto yourdestination track. If you make a mistake, just roll back and drop in. When you have finished, check the compositetrack for glitches, level changes or anything that doesn't fit, and if a section is not good, simply roll back and dothat section again.




4/4

Documents

Recording Vocals 3