Upload
florin-trif
View
25
Download
1
Embed Size (px)
DESCRIPTION
rcd 300 volkswagen
Citation preview
Thank you for buying our product. Please follow the instructions to install the emulator in your car. If you have any queries please do not hesitate to contact us on www.conofrei.com/support .
INSTALLATION
It is important that the installation sequence is followed to ensure complete and proper recognition by the factory
radio. 1. Switch off radio, turn off ignition and remove keys.
2. Disconnect the battery negative terminal (Ensure radio code is known or accessible). 3. Depending on where the Auxiliary Source is to be mounted you may need to run the audio cable to the desired
location where you want to keep your external player. 4. Using the appropriate radio keys, remove head unit from console.
5. Connect the black wire from the emulator, to a good earth point.
6. Locate CD Changer socket on back of head unit and connect the VAG CD Changer emulator white quadlock plug. 7. Reconnect negative battery terminal.
8. Verify full working operation via the radio. 9. Re-install the factory head unit into the console.
10. Mount the portable player in a desired mounting location .
.
VW RCD300 CD Changer Emulator Installation
First please remove the dash trim,
grab it from the lower edge, and pull,
hard ,try and pull where the clips are -
see the markings in the second photo
Pull the unit clear of the dash Next remove the four screws that hold the
head unit in place - you'll need a T-20
torx bit
As you pull the head unit clear, watch out
for the black rubber wedges that the unit
locates on, sometimes they come out with
the head unit.
Sometimes, they stay in situ, within the
dash
The Emulator requires an earth connection, the
case is earthed - so it can be fixed it on the top of
the head unit
Plug the big white block into socket B on the
rear of the RCD 300 .
Follow the steps described in the design.
Insert the white connector in the empty slot of the quadlock connector. There are 2 empty Slots but the CD Changer connector (white) only fits into one of the slots.
You may observe the sticker found on the Head unit itself for pinout nstructions.
Put everything back in reverse order. Be very careful when mounting the Head Unit fascia.
When connected the emulator will allow the audio from an auxiliary input (DVD, PSP, MP3 etc)
to be played through the vehicles speaker system via the CD mode on the OEM head unit.
WARRANTY
This product is covered by a 12 months warranty from the date of purchase.
TROUBLESHOOTING Make sure to ground the Black Ground Cable to a suitable Ground Connection, then route the Aux-In con-
nection to a convenient location, where you can easily access it. For detailed troubleshooting please contact us.
We take no Responsibility for any damage to your car stereo or your car. Please follow the installation instructions carefully.