Upload
jay-t-panistante
View
2
Download
0
Embed Size (px)
DESCRIPTION
rennigebrof
Citation preview
entify the letter of the choice that best completes the statement or answers the question.
1. The analog meter is characterized by:a.a sensitive moving pointer. b. a graduated scale for different ranges.c.a need to interpret readings between scale marks. d.all of these.
2. The digital meter is characterized by:a.high accuracy of measurements.b.fast response time.c.a need to interpret readings.d.limited range of possible measurements.
3.
To measure resistance, an ohmmeter must be:a.connected in series into the circuit.b.connected across the component in the circuit.c.connected in parallel with the component removed from the circuit.d.all of these.
4.
In using an ammeter, the following precautions should be observed before connecting leads:a.turn off power.c.set meter to highest scale.b.observe polarity.d.all of these.
5.
In using a voltmeter, the following precautions should be observed:a.turn off power.c.set meter to lowest scale.b.observe polarity.
d.connect across the voltage source.
6.
An analog ohmmeter must be adjusted before each measurement for:a.zero deflection.c.polarity.b.full scale deflection.d.maximum current.
7.
The testing for open, short or closed circuits is better known as:a.resistance testing.c.continuity testing.b.ohmmeter testing.d.circuit testing.
8.
In using a multimeter, the following precautions should be observed:a.selector mode set for volts, amps, ohms, etc.b.selector range set for anticipated reading.c.proper jacks used for probes.d.all of these.
9.
In using a DMM, the first digit is frequently a half-digit of:a.0c.2b.1d.1/2
10.
The loading characteristic of a multimeter on a circuit is measured in:a.ohms.c.amps.b.volts.d.all of these.