3rd Party UHF Module Installation

Quick Install Guide

1. Disconnect power code from power outlet.

2. Remove Top cover.

3. Connect cables to Tuner Board. Note J5 is

already there keep other cable for spare

4. Insert the Tuner Board to tuner hole at rear

cover.

5. Assemble washer, nut & screw. Note plastic

filler (on back is NOT needed after module is

installed) put it up (it is not USED)

6. Connect cables to main board.

7. Connect the antenna cable from IF OUT to

UHF REMOTE ANTENNA.

8. Assemble the Top cover.

J4 J5

Washer & nut Screw

J902 J901

IF OUT

UHF REMOTEANTENNA

Right & Left Screw position

Rear Screw position