i

Support Notes

QinQ for MEN-6328 & NSH-5509

Configuration Guideline

Alan & Kenric, VOLKTEK CORP.

April 22, 2014

Version 1.0

ii

Contents

1. PURPOSES .................................................................................................... 1

2. FACILITIES LIST .............................................................................................. 1

3. CONNECTION DIAGRAM .................................................................................. 1

4. CONFIGURATION STEPS .................................................................................. 2

4.1. VLAN AND QINQ CONFIGURATION ON MEN-6328(1) & MEN-6328(2) ................. 2

4.2. VLAN CONFIGURATION ON NSH-5509(1) & NSH-5509(2) .............................. 5

5. TEST RESULTS ............................................................................................... 9

1

1. Purposes

As the guideline how to configure QinQ on MEN-6328 & NSH-5509

2. Facilities list

Three computers (2 use as customer site, 1 use as management)

Two MEN-6328

Two NSH-5509

RJ-45, Fiber cables, SFPs

Console cable

Colasoft Ping Tool had installed

3. Connection Diagram

2

4. Configuration Steps

4.1. VLAN and QinQ configuration on MEN-6328(1) & MEN-6328(2)

In this case, two MEN-6328 have same configuration except IP address.

VLAN configuration

VLAN Setting

3

Tag Setting

Port Setting

4

QinQ configuration

VLAN Stacking

Notice: To make the management vlan operation, The tpid value of tunnel

port (25) should be the default setting (8100)

Add Selective QinQ rule

5

4.2. VLAN configuration on NSH-5509(1) & NSH-5509(2)

Two NSH-5509 have same configuration except IP address.

VLAN tag-base port-info and VLAN-id

VLAN table results

Table 1

6

Table 11

Table 12

Table 13

7

Table 14

Table 15

Table 16

8

Table 17

Table 18

Table 30

9

5. Test results

Use Colasoft Ping Tool to test the results

PC1 can ping PC2, Q-in-Q is working fine.

Management PC can ping two MEN-6328 and two NSH-5509.