1
24V Cyclic 100Ah Gel Battery Bank www.antares.co.uk/cyclic-duty-gel-batteries.html Intelligent Battery Gauge www.antares.co.uk/asc-compact-range.html 12V Cyclic 420Ah Gel Battery Bank ASC+ Compact 12V/190A www.antares.co.uk/pure-sine-wave-inverter.html Compact Sine Inverter 12V/3kW/230VAC www.antares.co.uk/universal-power-charger-800.html ANTARES Universal Power Charger 800 www.antares.co.uk TEMPERATURE SENSOR STATUS LED This diagram is a schematic only: PLEASE FOLLOW CONNECTION AND FITTING INSTRUCTIONS FOR EACH PIECE OF EQUIPMENT. THESE CAN BE DOWNLOADED FROM THE DOCUMENT FINDER AT www.antares.co.uk 24V Load www.antares.co.uk/diesel-generators.html www.antares.co.uk/battery-gauge.html Battery gauge Pro ANTARES 12.8V AC Loads Original Chassis This is starting point for your system, it represents your vehicles starter motor, alternator and start battery. The start battery is a key part of the system which needs protection against discharge to ensure vehicle starting is not compromised. Primary load Battery Protection - This will protect the engine start battery from discharging by the auxiliary system - Allows current to pass through from alternator to charge auxiliary batteries - The ASC+ Compact will insure that the vehicle starts every time - Assured start option can be built in - This unit is fully automatic and E-marked www.antares.co.uk/microactive-dc-dc-charging-system.html μActive Charger μActive Charger Generator ANTARES AC Inlet www.antares.co.uk/automatic-transfer-switch.html 1 2 1 2 2+2/20A Transfer Switch Universal Power Charger 800 12V/50A www.antares.co.uk/ac-inlet-system.html www.antares.co.uk/remote-options-for-compact-sine-inverter.html Compact Sine Inverter ANTARES Inverter Display control panel 12V regulated output www.antares.co.uk/cyclic-duty-gel-batteries.html Vehicle Primary Loads Starter Motor Alternator ORIGINAL CHASSIS Chassis GND *Not supplied by Antares Pure Sinewave AC Power - - Has built in low voltage shutdown battery protection - Converts at high efficiency - 12V/24V/36V/48V input voltages are available - The inverter control panel can be flush mounted in the dash of the vehicle The inverter will take DC in and convert to a pure sine wave AC output DC-DC Charging The μActive range are highly efficient DC-DC units - - Powerful and compact, with a wide input voltage range - High reliability with automatic recovery - Integral split charge option - Available as charger/converter/regulator/equaliser Cyclic Duty Gel Batteries pecifically engineered to be used where the battery is expected to be repeatedly charged and discharged as part of its normal day - Provide longer autonomy in cyclic applications - S - Completely sealed construction (non-spillabe, maintenance free) - The battery gauge monitors voltage, current, time remaining, consumed Ah, and remaining capacity - IP44 Splash proof front panel AC Switching and Charging - This can either be 110VAC or 230VAC or both at 20A 12V/24V/36V/48V variations - Safely allows power to be switched between any two or three AC sources - The Antares UPC charger accepts any input from 90-255VAC to charge a battery bank - Features an in-built 4-stage battery charge regime to suit many battery chemistry - Available in www.antares.co.uk ANTARES engineering with answers FM603354

Pure Sinewave AC Power - Antares TDC · - Allows current to pass through from alternator to charge auxiliary batteries - The ASC+ Compact will insure that the vehicle starts every

  • Upload
    ledung

  • View
    217

  • Download
    0

Embed Size (px)

Citation preview

Page 1: Pure Sinewave AC Power - Antares TDC · - Allows current to pass through from alternator to charge auxiliary batteries - The ASC+ Compact will insure that the vehicle starts every

24V Cyclic100Ah

Gel BatteryBank

www.antares.co.uk/cyclic-duty-gel-batteries.html

IntelligentBattery Gauge

www.antares.co.uk/asc-compact-range.html en

gin

eeri

ng w

ith

an

swer

sA

NTA

RES

ASC

+ c

om

pa

ct

12V Cyclic420Ah Gel Battery

Bank

ASC+ Compact12V/190A

www.antares.co.uk/pure-sine-wave-inverter.html

Compact Sine Inverter12V/3kW/230VAC

www.antares.co.uk/universal-power-charger-800.html

ANTA

RES

U

nive

rsal

Pow

er C

harg

er 8

00w

ww

.an

tare

s.c

o.u

k

TEMP

ERAT

URE S

ENSO

RST

ATUS

LED

This diagram is a schematic only: PLEASE FOLLOW CONNECTION AND FITTING INSTRUCTIONS FOR EACH PIECE OF EQUIPMENT.

THESE CAN BE DOWNLOADED FROM THE DOCUMENT FINDER AT www.antares.co.uk

24VLoad

www.antares.co.uk/diesel-generators.html

www.antares.co.uk/battery-gauge.html Battery gauge Pro

ANTARES

12.8V

AC Loads

Original ChassisThis is starting point for your system, it represents your vehicles starter motor, alternator and start battery. The start battery is a key part of the system which needs protection against discharge to ensure vehicle starting is not compromised.

Primary load

Battery Protection- This will protect the engine start battery from discharging by the auxiliary system

- Allows current to pass through from alternator to charge auxiliary batteries

- The ASC+ Compact will insure that the vehicle starts every time

- Assured start option can be built in

- This unit is fully automatic and E-marked

Pure Sinewave AC Power

The inverter will take DC in and convert to a pure sine wave AC output at a high efficiency. The Antares inverter has an in-built battery protection feature, and will cutoff when the battery voltage reaches 10.5V/21.0V. The inverter control panel can be flush mounted in the dash of the vehicle, this unit displays all diagnostic LED's such as, Power on, over voltage, under voltage, over temperature, output overload, power save, and has an on/off button.

DC-DC ChargingThe Antares Active range is a highly efficient micro-processor controlled powerful DC-DC charger/converter/equaliser. In this case a 12V battery bank s charging a 24V battery bank with a second channel configured to a regulated 12V output.

µ

www.antares.co.uk/microactive-dc-dc-charging-system.html ANTARES

µActive Charger

µActive Charger

Cyclic Duty Gel BatteriesThe Antares range of Gel batteries have been specifically engineered to be used where the battery is expected to be repeatedly charged and discharged, as part of its normal day operation. The Antares cyclic duty gel batteries are designed to be maintenance free and provide a longer autonomy in cyclic applications. The intelligent battery gauge monitors voltage, current, time remaining, consumed Ah, and remaining capacity.

AC Switching and ChargingThe Antares transfer switch allows power to be safely switched between any two or three AC sources. This can either be 110VAC or 230VAC or both and can switch up to 4.6kW. The Antares Universal power charger accepts any AC input from 90-255VAC and converts to a DC voltage to charge a battery bank. This unit features an in-built 4-stage battery charging regime, to suit a range of battery chemistry. Available in 12V/24V/36V/48V variations to suit the voltage configuration.

fischer Panda

Generator

ANTARES

AC Inlet

www.antares.co.uk/automatic-transfer-switch.html 1

2

1

2

2+2/20ATransfer Switch

UniversalPower Charger 800

12V/50A

www.antares.co.uk/ac-inlet-system.html

www.antares.co.uk/remote-options-for-compact-sine-inverter.html Compact Sine Inverter

ANTARES

Inverter Displaycontrol panel

12V regulated output

www.antares

.co.uk/cyclic

-duty-gel-ba

tteries.html

Vehicle Primary Loads

Starter Motor

Alternator

ORIGINAL CHASSIS

Chassis GND

*Not supplied by Antares

Pure Sinewave AC Power-

- Has built in low voltage shutdown battery protection

- Converts at high efficiency

- 12V/24V/36V/48V input voltages are available

- The inverter control panel can be flush mounted in the dash of the vehicle

The inverter will take DC in and convert to a pure sine wave AC output

DC-DC Charging The µActive range are highly efficient DC-DC units-

- Powerful and compact, with a wide input voltage range

- High reliability with automatic recovery

- Integral split charge option

- Available as charger/converter/regulator/equaliser

Cyclic Duty Gel Batteriespecifically engineered to be used where the battery is expected to

be repeatedly charged and discharged as part of its normal day

- Provide longer autonomy in cyclic applications

- S

- Completely sealed construction (non-spillabe, maintenance free)

- The battery gauge monitors voltage, current, time remaining, consumed Ah, and remaining capacity

- IP44 Splash proof front panel

AC Switching and Charging

- This can either be 110VAC or 230VAC or both at 20A

12V/24V/36V/48V variations

- Safely allows power to be switched between any two or three AC sources

- The Antares UPC charger accepts any input from 90-255VAC to charge a battery bank

- Features an in-built 4-stage battery charge regime to suit many battery chemistry

- Available in

www.antares.co.uk ANTARESengineering with answers

FM603354