Project Leonardo da Vinci

The car of the future

Created by Sebastián Simko, David Kiss & Roman Čorba

Motivation

We are the students of The Secondary Industrial School in Kosice

The content of our studies are AutoCAD, Inventor where we are modelling parts and mechanism.

The experiences we gained here will be useful for our future studies at the technical university.

Content

The parts which we created in :AutoCADInventor

The engine which we created :ModelAnimation

Our own future car

The parts which we created

AutoCAD

3D model created by lines first extruditions stand

Inventor

basic part clamping piece piston rod

AutoCAD

3D model created by lines:

In AutoCAD we created 3D objects by lines and coordinates system.

We focused on the basic functions.

AutoCAD

The first extruditions:

We used prespull and extrude to create solid.

We created solid by polylines and regions.

AutoCADStand:

At last we did the stand.

We could create render picture where we could change backround, lights, etc.

Inventor

Basic part:

we created part where we could try fillet, chamfer, hole, milling slot and other basic functions.

Inventor

Clamping piece:

This model is very hard as for modeling.

We had to use plane interact extrude thread and good orientating in coordinate system.

Inventor

Piston rod:

This is the first part of the engine which we created.

We also created these parts at school. This model checked our skills and knowledge.

Engine

This was the last assembly, which we created on the lesson.

This is a fully functioning model.

Our own future car This is our main project, which we focused on the most. This car is designed to recall the car of the future. This car is very narrow, is customized for one man.

Thank you for your attention