PROLiNK® PRN2001 Repeater Installation Guide

You must have the wireless security password of your main wireless router ready before setting up the PRN2001. If you’re unsure how to check, please consult with your main wireless router

vendor. 1) Connect a LAN cable from the PRN2001 LAN port to your PC/laptop LAN port. 2) Access http://192.168.123.254 (enter admin as usernameusernameusernameusername, password as passwordpasswordpasswordpassword) on your

Internet browser.

3) Click Wireless Settings > Wireless Basic Settings > Authentication: Select “WPA2-PSK” > Encryption: Select “AES” > Encryption key: Enter your desired wireless password (min 8 characters), and click Apply.

4) Click Wireless Settings > Wireless Repeater > Select “Repeater Bridge” under Wireless

Repeater, then click “Scan AP”

Version: 2.00

Date: March 2013

5) An AP List window will pop up, select your desired wireless network (SSID) to repeat, and click “Select AP”

6) Enter the main wireless router password in Encryption Key, click Apply

Your main wireless router password

7) If the repeater bridge is connected successfully, you will see the link rate and signal power under Wireless Status > Repeater bridge status

8) Go to Network Settings > LAN/DHCP Server. Choose Disable for DHCP Server. Click Apply.

9) PRN2001 will restart. You can disconnect the LAN cable from your PC/laptop now. On your

wireless PC/laptop, scan for the wireless network. You should see the SSID for the PRN2001 that you have changed (or default if you did not change). Double click on it. You should be prompted to enter the wireless password you have set in step 3. If the password you entered is correct, you should be able to connect to the PRN2001. Once connected, you should be able to get the internet from your main wireless router.