PRACTICA ETAPSABRIMOS EL PROGRAMA: Entramos a MENU (file-new
model) En Model Initialization cambio en (use built-in settings
with) Display units (Metric SI) OK New Model quick templatesNumber
Lines in X Direction = 4 Number of Stories = 2Number Lines in Y
Direction = 3 Typical Story Height = 2.8Spacing in X Direction = 7
Bottom Story Height = 4.5Spacing in Y Direction = 8
Modificamos las dimensiones en X-Y de acuerdo al ejemplo
mencionadoCustom grid spacing (Edit grid data) Grid system
dataDisplay grid data ordinates X grid data Y grid dataA=0 1=0 B=6
2=7C=14 3=16D=20 OK- OK
Definimos material (define-material properties)1. Define
materials add new material Define materials add new material
property (material type-other)
OK- OK
material property dataMaterial name: MATERIAL UNICOPoissons
Ratiu.U: 0.3 OK- OK 2. definimos seccion (section properties Frame
section) frame properties-Type: ALL- add new property
frame properties shape type-Section shape: GENERAL- Concrete
rectangular frame section property dateCOLUMNAS Y VIGAS Property
name: C-1(60x80)igual manera para la C-2(40X60) Material: MATERIAL
UNICO Depth: 800mm Width: 600mmIgual manera para la C-2(40X60),
V-1(30X60), V-2 (30X30)
OK-OK
3. Definimos material para lozas (Define materials add new
material) material property dataMaterial name: LADRILLO
15IGUALMENTE PARA LADRILLO DE 25Poissons Ratiu.U: 0.2 OK- OK 4.
definimos seccin para lozas (section properties slab secctions)
slab properties add new property slab property dataProperty name:
LOZA 30cmIGUAL MANERA PARA (L-20Cm) LADRILLO15Slab material.
LADRILLO25Type: slabThickness: 300OK- OK
5. definimos patrn de carga (load paterns) define load
patterns-CM-dead-1 add new load OKCV-dead-1 add new load
OKFL-other-1 add new load OKFS-other-1 add new load OK6. definimos
Casos de carga (load cases) load cases- add new caseLoad case name:
CASO 1 add (patern CM 1) OK CASO 2 add (patern CV 1) OK CASO 3 add
(patern CM 1) OK CASO 4 add (patern CM 1) OK- OK7. definimos
Combinacin de carga (load combinations) load combinations: add new
comboLoad combination name: COMBO 1 (CASO1 +CASO2) add OK COMBO 2
(COMBO1 +CASO3) add OK COMBO 3 (COMBO1+ CASO3 + CASO 4) add OK -
OK
