Upload
others
View
3
Download
0
Embed Size (px)
Citation preview
Page 1 of 15
Post Process & Plot Inbuilding Data on Floor Plan Using MapInfo:
This information based on MapInfo Professional Version 11.0 (there is a slight difference for other versions)
From iMeasure session folder open (*_FloorPlan.TAB) file
This will open the floor plan in map info as seen below
Page 2 of 15
1- Open your session
3- Select “Comma delimited CSV (*.CSV)”
4- Select “Current Mapper”
2- Select (*.CSV) session file
5- Click open
Page 3 of 15
6- Check this box
7- Click ok
Page 4 of 15
8- Click ok
Click ok if this message appears, if not, than go to the next step
Page 5 of 15
9- Select the table tab
10- Select Create Points
Page 6 of 15
11- Select your table if there is multiple open
12- Click “Projection”
13- Select “None Earth”
14- Select “None Earth (feet)”
15- Click ok
Page 7 of 15
16- Enter at “Max X: 2000”
17- Enter at “Max Y: 2000”
18- Click ok
Page 8 of 15
19- Make sure is X selected
20- Make sure is Y selected
21- Click Ok
Page 9 of 15
22- From the layers click add or “+”
23- Select the table (select the correct table you need to plotted) usually is last one
24- Click Ok
Page 10 of 15
That’s what you will see
Page 11 of 15
To create thematic
25- From Map tap
26- Select “Create Thematic Map”
Page 12 of 15
27- Select your template Thematic
28- Click Next
Page 13 of 15
29- Select the table
30- Select the element (RSCP, EcIo,….) you need to plotted ==
31- Click Next
Page 14 of 15
32- Click Ok
Page 15 of 15
Here you will see your plot