Polaris Predator Installation Manual Slide 2 STEP 1: Remove ATV
Rear Tires Remove ATV right side wheel hub Remove ATV stock swing
arm (2 bolts) 1-855-KTRACKS Slide 3 STEP 2: Install track kit swing
arm mounting bracket 1-855-KTRACKS Slide 4 STEP 3: Remove the two
caliper mounting bolts Remove the caliper 1-855-KTRACKS Slide 5
STEP 4: Loosen brake disc hub SHCS Turn hub counterclockwise so the
snap ring can be removed Turn the hub clockwise to remove mark and
note the number of turns the hub adjusts carrier bearing preload
1-855-KTRACKS Slide 6 STEP 5: Remove brake disc Remove retainer
ring Remove ATV stock rear brake caliper mounting plate
1-855-KTRACKS Slide 7 STEP 6: Install track kit brake caliper
relocation mounting plate Reinstall ATV brake disc, brake disc hub
and snap ring Adjust the disc brake hub and tighten the SHCS to
lock in place 1-855-KTRACKS Slide 8 STEP 7: Reinstall the ATV rear
caliper install and tighten two bolts 1-855-KTRACKS Slide 9 STEP 8:
Install the RH & LH track assemblies 1-855-KTRACKS Slide 10
STEP 9: Install the kit swing arm Position the track kit swing arm
as shown and rotate into place 1-855-KTRACKS Slide 11 STEP 10:
Install supplied swing arm mounting bolt and washer Install
supplied washer and Nyloc nut 1-855-KTRACKS Slide 12 STEP 11:
Install supplied (4) 5/16 bolts & (2) retainer plates Install
and tighten (4) Nyloc nuts 1-855-KTRACKS Slide 13 Assembly Picture
Slide 14 STEP 12: Install 3 rd link assembly: (See next pages)
1-855-KTRACKS Slide 15 STEP 13: Relocate ATV stock negative ground
wires Install 3 rd link onto frame Install supplied (2) SHCS and
tighten 1-855-KTRACKS Slide 16 STEP 14: Install 3 rd link bar with
supplied bolt and Nyloc nut 1-855-KTRACKS Slide 17 STEP 15: Initial
Track Adjustment: 1-855-KTRACKS Measurements must be taken off head
of 1/2- 13NC (rear) and 5/8-11NC (front) bolts flat to flat Adjust
to 18 1/8 inches Measure from this point Measure to back of Bogey
mount Adjust to 9 NOTE: Both sides must be adjusted equally
