Planmeca ProMax Installation Instructions for Terminal Services Version: 12.0 Date Created: 8/19/05 Last Modified: 11/9/05Filename: Planmeca ProMax Terminal Services

Required materials: Required EagleSoft modules: Install on the following computers: • Digital Integration CD • Planmeca ProMax Calibration

files • Planmeca ProMax connected to

the network

• Integrated Digital X-Ray • The terminal server computer only

1. Click on the Start button and click on Run.

2. Type in cmd and click ok

3. Type in change user /install and press <Enter>

Page 1 of 11

Page 2 of 11

4. Type in exit and press <Enter>

5. Click on Start -> Settings -> Control Panel

6. Double click on Add or Remove Programs

Page 3 of 11

7. Click on Add New Program on the left of the screen and then click on the CD or Floppy button.

8. Click Next

9. Make sure the open line is d:\setup.exe (where d is their CD drive letter) and click Next.

Page 4 of 11

10. Click on the Planmeca I/O – Panoramic button to install the integration.

11. Click Next

12. There will not be a calibration disk for the ProMax pan, so just click Next

13. Will get the following error message, just click Ok and continue with installation.

Page 5 of 11

14. Click No

15. Click on No to set the default digital x-ray device

16. Click on Finish

17. A second installation wizard should come up. Click on Next.

18. Click on Next.

Page 6 of 11

19. Click on Next.

20. Click on Next.

21. Uncheck the box for the readme file and click on Finish

22. Click the circle next to the No, I will restart my computer later option and then Ok.

Page 7 of 11

23. Click Next.

24. Click Finish.

25. Close the Add or Remove Program window.

Page 8 of 11

26. Close the Control Panel window. 27. Restart the computer

28. Click on Start button and Run

29. Type in cmd and click ok.

Page 9 of 11

30. Type in change user /execute and press <Enter>

31. Type in Exit and press <Enter>

32. Open My Computer and browse to C:\Program Files\EagleSoft\Shared Files and double click on

DidapiConfig.exe

Page 10 of 11

33. Click on the Ethernet Interface tab and then the OpenPromaxEthernetConfig.txt button.

34. Click on Yes to create the file.

35. Type in localhost= then the IP Address of the pan machine :5000, an example is

localhost=10.94.39.12:5000

Page 11 of 11

36. Click on File -> Save and then close the window

37. Click on the Refresh button for ProMax Ethernet Interface and then click Apply and Ok. 38. Make sure that the calibration files for the ProMax are in the EagleSoft\Shared Files folder on the server. 39. Try taking an image with the pan machine.