Garmat® USA provides parts jamming booths to meet your
shops’
small parts requirements. Parts jamming booths are designed
for
priming or finish painting. They recycle the filtered air back
into the
shop environment.
Garmat® USA Parts Jamming Tunnels are constructed of e.g.
steel
with durable powdercoated finish on facia and ceiling panels.
Both
units are equipped with a reverse incline fan, 5 HP motor, 3
phase.
Complete electrical controls include motor starter and on-off
switch.
Two stages of filtration are provided. Efficient air flow of
9,000 CFM.
PARTS JAMMINGBOOTHS
10811Single Wall Panel ConstructionOne 5 HP Motor8 – T8
Fluorescent Tube Overhead Light Fixtures8’3” wide
10812Single Wall Panel ConstructionOne 5 HP Motor16 – T8
Fluorescent Tube Overhead Light Fixtures11’ 53/4” wide
1401 W. Stanford Ave. Englewood, CO 80110 Phone: 800-442-7628
Fax: 303-781-2683 www.garmat.com
BUILT IN THE
USAGarmat® USA reserves the right tomodify or change any of the
technicalfeatures mentioned in this brochure.©2002 Garmat® USA
MODEL10811
MODEL10812
