Huawei Technologies Proprietary

Overview

Operation Guide

Appendix

CM Express Acceptance Manual

V200R015C00SPC100

Huawei Technologies Co., Ltd. Website: http://support.huawei.com

E-mail: support@huawei.com

All Rights Reserved.

Address: Huawei Technologies Co., Ltd., Bantian, Longgang District, Shenzhen, P. R. China

Postal Code: 518129

Version: 20140710-B-1.0

CM Express Acceptance Manual Internal Use Only

Huawei Technologies Proprietary

Content

Part I Overview ........................................................................................................................1

1 Grounds for Acceptance Tests ......................................................................................... 1

2 Contents of the Manual .................................................................................................... 1

3 Numbering of Acceptance Test Items ............................................................................... 1

4 Matters for Attention ........................................................................................................ 1

iManager U2000-CME Mobile Element Management System Acceptance Manual For internal use only

Huawei Technologies Proprietary

Part I Overview

1 Grounds for Acceptance Tests

This manual is written in conformity with recommendations and international standards, with modifications to reflect the characteristics of Huawei equipment and solutions .

Upon completion of the project, an acceptance test team that consists of the customer

and Huawei engineers shall carry out the acceptance test to ensure that the equipment or system complies with the requirements.

2 Contents of the Manual

This manual applies to Huawei CM Express V200R015C00SPC100.

This manual consists of three parts:

Part I Overview introduces the grounds for acceptance tests, contents of the manual, numbering of acceptance test items, and matters for attention.

Part II Operation Guide describes in detail the testing procedures for all items. It

serves as a reference for acceptance tests. Part III Appendix includes the dial-up access test and the cover sign-off sheets

for the acceptance tests.

3 Numbering of Acceptance Test Items

Acceptance test items are usually numbered in a six-digit format as follows:

TXX-XXXX Test sub-item

Test item

Test category

4 Matters for Attention

Pay attention to the following points for the acceptance tests:

Before starting the tests, make sure that the system is correctly installed, the software and hardware commissioning is completed, and the system runs

normally. The test items shall be agreed on by the two parties concerned. Observe the relevant rules during the tests. You can omit some items that have

been tested before delivery if the site conditions are not appropriate.

iManager U2000-CME Mobile Element Management System Acceptance Manual For internal use only

Huawei Technologies Proprietary

Note:

In the acceptance tests, observe the contracts and agreements between the two

parties concerned. This manual serves as a reference only.