Upload
others
View
2
Download
0
Embed Size (px)
Citation preview
Phone: 717.235.6807 • www.oakworks.com
PROLUXE™
ADJUSTMENT & ASSEMBLY INSTRUCTIONSTable Skirt
made in the USAwith US & imported parts
TIGHTEN TABLE SKIRT SUPPORT CORD
page 1 www.oakworks.com
If ordered with the table, your ProLuxe™ Skirt is pre-installed and ready for use.Minor adjustments may be required as follows:
STEP 1 - Locate the cord locking clamp.The Cord Locking Clamp is located at the motor end of the table.
TIGHTEN TABLE SKIRT SUPPORT CORDThis will need to be done if the skirt is sagging in the middle of the table as shown here.
STEP 2 - Tighten the cord.With one hand, grasp the clamp. With the other hand, grasp the cord. Pull the cord out of the locking groove. Pull cord tight around the table and re-insert the cord into the locking groove.
Check the skirt all around the table. Repeat procedure if additional tightening is required.
STEP 3 - Adjust the skirt pleats to your desired look.
loose tight
CORD LOCKING CLAMP
Shown here on ProLuxe™ table with ABC system.
www.oakworks.com page 2
TO RE-ATTACH THE PROLUXE SKIRTIf your ProLuxe™ Skirt has not been assembled with the table, or the ProLuxe™ Skirt has been washed, follow the procedure below to re-attach the ProLuxe™ Skirt.
STEP 1 - Locate the panel opposite the cord locking clamp.
CORD LOCKING CLAMP
STEP 2 - Be sure the best face of the skirt is facing out.
STEP 3 - Locate the visible cord at the ends of the panel. (shown above) Insert the cord into the groove of the 2 wood supports located at the end of the table opposite the table motor.
VISIBLE CORD
Wood support with cord inserted.
STEP 4 - At the other end of the table (the side with the motor), insert the visible cord at the end of the next skirt panel into the groove of the two wood supports.
Wood support with cord inserted.
Insert this set of cords on the opposite side of
the table motor.
STEP 5 - Follow instructions “Tighten Table Skirt Support Cord” (page 1) to tighten & adjust the skirt to your desired look.
Shown here on ProLuxe™ table with ABC system.
ProLuxe™ Table Skirt Instructions Part no. MMINSH0010 Rev. 80311
OAKWORKS®, Inc.923 East Wellspring Rd.New Freedom, PA 17349
Phone: 717.235.6807 FAX: 717.235.6798
www.oakworks.com
NOTE: OAKWORKS® is not liable for injuries
or damages sustained when table is not used in the manner prescribed.
TABLE SKIRT CARE INSTRUCTIONS
WASH in warm water.
Do not use bleach.
DRY on low heat.
Light iron if necessary.
You may leave the fabric on the cord for easy re-attachment to the table.
BLEACH