Upload
others
View
0
Download
0
Embed Size (px)
Citation preview
Oppo X9000 Power Button ReplacementReplace the power button from your Oppo X9000.
Geschrieben von: Joe Hanacek
Oppo X9000 Power Button Replacement Entwurf: 2014-12-19Anleitung Nr: 31581 -
© iFixit — CC BY-NC-SA de.iFixit.com Seite 1 von 6
EINLEITUNG
This guide is for replacing the power button, not the electric switches.
WERKZEUGE:Spudger (1)Phillips #0 Screwdriver (1)iFixit Opening Tools (1)
Oppo X9000 Power Button Replacement Entwurf: 2014-12-19Anleitung Nr: 31581 -
© iFixit — CC BY-NC-SA de.iFixit.com Seite 2 von 6
Schritt 1 — Removing the Back Cover
Turn the phone over so that you are facing the back side of the phone.
With your fingers, pry the back cover up starting from the top of the phone near the headphonejack and camera.
Completely remove the back cover by moving down the sides and bottom with your fingers.
Schritt 2 — Removing the Battery
With your finger, remove the batteryfrom the phone by gently lifting thetop-right corner nearest to thecamera.
Oppo X9000 Power Button Replacement Entwurf: 2014-12-19Anleitung Nr: 31581 -
© iFixit — CC BY-NC-SA de.iFixit.com Seite 3 von 6
Schritt 3 — Remove the Back Panel Screws
Remove the twelve exposed 3.6 mm Phillips screws on the rear of the phone using the 3.6 mmPhillips screwdriver.
Store all the screws in a safe place where you will not lose them.
Schritt 4 — Remove the Rubber Stoppers
Remove the three circular rubber screw covers on the back of the phone by slipping the spudgerinto the border between the rubber cover and the chassis. In one motion, pry the stopper out of thehole. This can take some force.
Oppo X9000 Power Button Replacement Entwurf: 2014-12-19Anleitung Nr: 31581 -
© iFixit — CC BY-NC-SA de.iFixit.com Seite 4 von 6
Schritt 5 — Remove the Newly Exposed Screws
With the 3.6 mm Phillipsscrewdriver, remove the three newlyexposed 3.6mm Phillips screws.
Schritt 6 — Lift off the Back Panel
Insert the plastic opening tool underneath the chassis near the power button and pry the chassisfrom the phone. This should take a little force.
Oppo X9000 Power Button Replacement Entwurf: 2014-12-19Anleitung Nr: 31581 -
© iFixit — CC BY-NC-SA de.iFixit.com Seite 5 von 6
To reassemble your device, follow these instructions in reverse order.
Dieses Dokument wurde zuletzt angelegt am 2019-08-27 09:05:01 AM.
Schritt 7 — Remove the Power Button Bracket
Use the sharp end of the spudger topry the power button bracket fromthe side of the rear case.
Schritt 8 — Let the Button Fall Out
Rotate the phone onto its side sothat the power button falls out withease.
Make sure not to lose the powerbutton.
Oppo X9000 Power Button Replacement Entwurf: 2014-12-19Anleitung Nr: 31581 -
© iFixit — CC BY-NC-SA de.iFixit.com Seite 6 von 6