NetApp Certified Implementation Engineer - SAN

Exam: NS0-502

CCCEEERRRTTT MMMAAAGGGIIICCC

Demo Edition

NS0-502

1 http://www.certmagic.com

QUESTION: 1Click the Exhibit button.

You see the following error on the storage controller's console or messages file.What is the most likely cause for this error?

A. portal group misconfigurationB. iSCSI CHAP misconfigurationC. iSNS misconfigurationD. IPsec misconfiguration

Answer: B

QUESTION: 2What would you use to share a data LUN among multiple servers where each serverhas simultaneous write access?

A. host-based BootBIOSB. host-based multipathingC. host-based volume managerD. host-based clustered file system

Answer: D

QUESTION: 3Click the Exhibit button.

NS0-502

2 http://www.certmagic.com

In the diagram shown, a portset is created on controller 1 with the command:controller1>portset create -f ntapportset 0b. This portset is bound to the igroup withall the initiators in it.How many paths can host 1 see to a LUN on controller 1?

A. six pathsB. four pathsC. eight pathsD. two paths

Answer: D

QUESTION: 4What are three relevant perfstat counters to check for unaligned I/O that do not fallon the WAFL boundary? (Choose three.)

A. wp.partial_writeB. vvol_read.io_validC. read/write_align_histo.XXD. read/write_partial_blocks.XX

NS0-502

3 http://www.certmagic.com

E. xinode content misses

Answer: ACD

QUESTION: 5Click the Exhibit Button

The table highlights the space management policy that is defined for a particularflexvol, acmevol. Based on the information provided in the table, which action willthe storage controller take when it runs out of space in the volume?

A. It will try deleting Snapshot copies first to reclaim space before trying to growthe volume.B. It will grow the volume before deleting Snapshot copies.C. It will only try deleting Snapshot copies to reclaim space and will not grow thevolume.D. It is irrelevant since fractional_reserve is 0%.

Answer: C

QUESTION: 6Which utility on Windows 2003 and Windows 2008 can be used to collectinformation about firmware and driver versions for an Emulex LP1xxxx/LPe1xxxHBA?

NS0-502

4 http://www.certmagic.com

A. EMutilB. SANutilC. fcp configD. SANsurferE. HBAnywhere

Answer: E

QUESTION: 7Which utility on Solaris 10 can be used to collect information about firmware anddriver versions for an Emulex LP1xxxx/LPe1xxxx HBA?

A. EMutilB. SANutilC. hbainfoD. SANsurferE. HBAnywhere

Answer: E

QUESTION: 8Which utility on Solaris 10 can be used to collect information about firmware anddriver versions for a Qlogic QLAxxx/QLExxxx HBA?

A. EMutilB. SANutilC. cfgadminD. SANsurferE. HBAnywhere

Answer: D

QUESTION: 9An organization currently has a NetApp Fibre Channel block-based solution. Withlimited budget and resources, they want to create a new disaster recovery site thatutilizes a NetApp solution.What would the optimal solution include?

NS0-502

5 http://www.certmagic.com

A. SnapMover and Fibre Channel at the disaster recovery site for all hostsB. SnapMirror and iSCSI at the disaster recovery site for all hostsC. Fibre Channel at both locations using ftp to replicate storageD. MetroCluster and NAS

Answer: B

QUESTION: 10A company has a Fibre Channel environment and wants to connect a new host in aremote data center using 50/125um OM2 multi-mode fiber cable and needs tosupport 2 Gb speeds.What is the maximum distance of the cable run supported inthis situation?

A. 50/125um OM2 multi-mode fiber cable supports up to 500 meters at 2 Gb.B. 50/125um OM2 multi-mode fiber cable supports up to 10000 meters at 2 Gb.C. 50/125um OM2 multi-mode fiber cable supports up to 150 meters at 2 Gb.D. 50/125um OM2 multi-mode fiber cable supports up to 300 meters at 2 Gb.

Answer: D

QUESTION: 11Click the Exhibit button.

NS0-502

6 http://www.certmagic.com

Given the information provided in the diagram, what is the appropriate FCtopology?

A. point-to-pointB. switched fabricC. arbitrated loopD. ring

Answer: B

QUESTION: 12Which FC SAN topology provides the best performance and scalability?

A. cascadeB. core-edgeC. full meshD. partial mesh

NS0-502

7 http://www.certmagic.com

Answer: B

QUESTION: 13Click the Exhibit button.

Based on the diagram shown, what is the appropriate FC switch topology?

A. full meshB. core-edgeC. full cascadeD. partial mesh

Answer: B

QUESTION: 14Click the Exhibit button.

NS0-502

8 http://www.certmagic.com

Based on the diagram shown, what is the appropriate FC switch topology?

A. core-edgeB. full meshC. partial meshD. partial cascade

Answer: C

QUESTION: 15A 200-GB LUN is created in an empty 500-GB volume with the volume guaranteeoption set to Volume. LUN reservation is enabled and the fractional reserve is set to100 and scheduled snapshots are disabled.Directly after LUN creation, what is themaximum free space available in the volume?

A. 200 GBB. 300 GBC. 400 GBD. 500 GB

Answer: B

QUESTION: 16A 100-GB thinly provisioned LUN is allocated to a Windows host. 100 GB of datais written into the LUN. The current capacity utilization on the disk array as well asthe host is 100%. 50 GB of data is deleted from the LUN. Space reclaimer has NOTbeen run.What is the current capacity utilization on both the host and the disk array?

NS0-502

9 http://www.certmagic.com

A. 50% on the host, 100% on the disk arrayB. 100% on the host, 50% on the disk arrayC. 50% on the host, 50% on the disk arrayD. 100% on the host, 100% on the disk array

Answer: A

QUESTION: 17A customer has a four-node SUN cluster configuration. Each node has two, dual-ported HBAs. What is the minimum number of igroups that need to be created tomap a LUN to the cluster?

A. 1B. 2C. 4D. 8

Answer: A

QUESTION: 18Zoning by World Wide Port Name (WWPN) is deployed and a host HBA isreplaced. Which zone change needs to be made?

A. No changes are necessary.B. The zone configuration should be changed to include the port to which the HBAis connected.C. The zone configuration should be changed to include the WWPN of the newHBA; the old WWPN will be automatically dropped.D. The zone configuration should be changed to include the WWPN of the newHBA and to remove the WWPN of the old HBA.

Answer: D

QUESTION: 19Which three protocols can be used for communications between a host runningSnapDrive for Windows and the NetApp Storage Controllers? (Choose three.)

A. http:

NS0-502

10 http://www.certmagic.com

B. https:C. ftp:D. RPCE. ssh

Answer: ABD

QUESTION: 20Any newly installed system with Data ONTAP 7.3.1 supports which cfmode?

A. dual_fabric onlyB. single_imageC. partnerD. mixed

Answer: B

NS0-502

11 http://www.certmagic.com