Upload
others
View
1
Download
0
Embed Size (px)
Citation preview
NOTE: Picture may be different than actual product!
This is a reference guide only!
Step 1
Remove the front bar and the reinforcement bar.
Step 2 Remove the standard top mount intercooler
and brackets etc...
Step 3 Remove cold air flow box and disconnected
the Air Flow Meter.
Step 4 Put cable behind Bracket!
Step 5
~Install Piping~ *Attach Air Flow Meter Pipe
(Note: Attach Air Flow Meter Back to pipe)
* Assemble cold air intake pipe to the Air Flow Meter Pipe
* Connect Air Pod to the cold air intake pipe as seen in the picture
* Attach Top Driver Side Pipe to the throttle as seen in the picture.
(NOTE: Be sure to mount bracket securely.)
* Attach Bottom Driver Side Pipe to the bottom of the Top Driver Side Pipe, which runs
from the throttle.
* Attach Top Driver Side pipe to turbo outlet.
* Attach Middle passenger side pipe to the bottom of the Top Driver Side Pipe, which runs from the turbo.
*Attach Bottom Passenger Side Pipe to the bottom of the Middle Pipe.
*Trim plastic
guard tray enough so that
it doesn’t interfere with
the intercooler or
it’s piping.
*Mount the Hybrid Intercooler Brackets & the Hybrid Intercooler
into position
and connect
the piping
*Trim front bar back just enough to avoid it rubbing on the Hybrid Intercooler and it’s piping.
*Double check all the piping
and clamps to make
sure everything
is tightened
and correctly
into position.
WARRANTY: LIMITED WARRANTY Powerdigger.com Pty Ltd will warranty for the period of 1 year from original purchase against all defects in workmanship and materials. Powerdigger.com Pty Ltd is not responsible for expenses incurred for labour, personal injury or inconvenience. Powerdigger.com Pty Ltd cannot warranty products damaged by improper installation or used for racing, off-road use. All other products sold by powerdigger.com Pty Ltd are warranted by the original manufactures and is not the responsibility of Powerdigger.com Pty Ltd.