new 1

Embed Size (px)

DESCRIPTION

123

Citation preview

NOTE: 5.7.3.011 is not available for selection on Found in Release field so I've selected 5.7.3.009.The issue is on 5.7.3.009 .1. Problem Description=======================NEW: Locked console on BU after downloading config from EDM (USB)2. Problem Scope:============================================F/W Release (Software image and Diagnostics Code): SW: 5.7.3.011Also reproducible on 5.7.2.0133. Steps to reproduce:=======================Have a defaulted stack.My stack was:4550T-PWR+(config)#sh stack-iUnit# Switch Model Pluggable Pluggable Pluggable Pluggable SW Version Port Port Port Port----- ---------------- --------- --------- --------- --------- ----------1 4526T-PWR+ (25) None (26) None v5.7.3.0112 4550T-PWR+ (49) None (50) None v5.7.3.0113 4550T-PWR+ (49) None (50) None v5.7.3.011On EDM, download config from USB (my USB was on unit 2) and wait 15 minutes for the DUT to log-out.4. Expected Result:===================The stack should log-out and the banner should appear.5. Actual Result:===================Only on BU I have the following message:"Forced log-out after 300 secs." and the console is locked.On NBU the banner appeared correctly.6. Impact (e.g. key focus description, such as Traffic Loss, Display Issue... how it impacts a real customer network)=====================================================================================================================7. Workaround and/or Steps to recover from problem (if known):==============================================================Boot stack, issue command telnet-access inactive-timeout 0 or wait for another 10 minutes for the banner to appear and the console is working again.8. Supplemental Data (Debug, Logs or Cores):============================================9. Contact Information:=======================Originator Contact Name: Mihai VoineaEmail address: [email protected]. WI Source (Test Case ID, RTV, Ad-Hoc, Retest: If Test Case, RTV or Retest, enter a lognote with the TC ID (Full Folder Path), and set the Log Description Type to 'Test Planning') ============================================================Ad-Hoc