Environment
System specifcations
Operating temperature
Moisture resistance
Vandal Resistance
Net2 Entry - Control unit/Extension switch
DS1054
100m/328ft
100
0°C - +45°C+32°F - +113°F
Features
Power over Ethernet (PoE)
Panels per system
TCP/IP ethernet extension limit
Ethernet bandwidth requirement
Cable type
1Mb/s multicast per panel during call
CAT5
Yes
Yes
Yes
Yes
- IEEE 802.3af class 0
No - if used externally, it must be protected in a weatherproof
housing
Low
Optional
Net2 Entry is a door entry system that works standalone or
alongside Paxton’s Net2 access control, combining door entry with
key features of Net2. Net2 Entry consists of 3 components that
auto-detect on set up; external panel, interior monitor and door
control unit.
Net2 Entry is a plug and play solution that comes with a range
of panel options and is suitable for a wide variety of sites.
Net2 Entry components simply interconnect using Cat5 or standard
RJ45 terminated patch cables. Net2 Entry can also utilise existing
network infrastructure for simple installation. PoE technology runs
power and data along the same cable to avoid the need for separate
power supplies.
The Net2 Entry control unit is the central interface between a
panel and the door and provides data and PoE power for the
monitors. The ports can also be used to expand the network of
panels and monitors through Net2 Entry extension switches or to
connect the control unit to a Net2 system running Net2 v4.25 or
later.
The Net2 Entry extension switch allows more monitors to be
connected to the Net2 Entry system. It is connected to the system
using one of its network ports and communicates using IPv6.
4 way PoE switch
Back up battery
Tamper switch
Mains monitoring
Note: for Net2 plus specifications and features, please refer
to
DS1039
YesFitting kit
