MSDS -Polyelectrolyte STI Oriental

7/26/2019 MSDS -Polyelectrolyte STI Oriental

http://slidepdf.com/reader/full/msds-polyelectrolyte-sti-oriental 1/5

521/522, 2nd Floor, Solitaire Corporate Park, Bldg. No. 5, Andheri Ghatkopar Link Road, Chakala Andheri (E),

Mumbai – 400093, India. Tel: +91 22 42144545/+91 22 28215995 | Fax: +91 22 28302612

www.shreetechinternational.com

Dated: June 2016

MATERIAL SAFETY DATA SHEET

SECTION 1 :IDENTIFICATION OF THE MATERIAL AND SUPPLIER

Product name POLYELECTYROLYTE STI

Other names AS A IRON SETTLING AGENT

Recommended use :As a additive in water flux .

Manufacturre & supplier.

SHREE TECH INTERNATIONAL :Tel no :0091-22-28215995/28344604521/522 Solitaire Corporate Park BLDG no 5 :Fax 0091-22-28302612

Chakala . Andheri East

Mumbai 400 099 IndiaPRODUCT INFORMATION PHONE :0091-22-42144545

SECTION II :HAZARD IDENTIFICATION.

Emergency overview

CAUTION: CAUSES IRRITATION TO SKIN , EYES AND RESPIRATORY TRACT

Health rating 1

Flammability rating :0

Reactivity Rating :0

Contact rating :2

protective equipment :Goggles, vent hood , proper glovesInhalation: Inhalation of the vapors may cause irritation to respiratory Tract. Excessive contact isknown to cause damage to Nasal Tract.

Ingestion: Toxic effects described in animals due to short exposure include corrosion of mucous

surfaces.

Human Health effects of overexposure by Inhalation , ingestion or skin or eye contact mayinitially include eye irritation , tearing or blurring of vision. Skin irritation with discomfort or

Rash or irriation of upper respiratory passages.Individuals with preexisting diseases of the lungs

may be having increased susceptibility to the toxicity of execessive exposure.Eye contact :contact may be corrosive to eyes..

SECTION III : COMPOSITION & INFORMATION ON INGRADIENTS.

CHEMICAL CHARACTERISTICS :

MIXURE:

Diammonium Phosphate : 60% to 65%

AMMONIUM LIQUID :2% to 3%






Water as solvent 30% to 55%CAS NO OF INGRADIENTS: 7783-28-0

SECTION IV : FIRST AID MEASURES.

Inhalation:remove to fresh air .if not breathing give artificial respiration .if breathing is

difficult give oxygen.Get medical attension.

Ingestion: If swallowed do not induce vomiting.give large quantity of water.Never giveanything by mouth to an unconscious person.Call physician immediately.

Skin contact: Immediately flush skin with plenty of water.. remove contaminatedclothing. Call physician immediately.

Eye contact: Immediately flush with plenty of water for atleast 15Mins, lifting lower &

upper eyelids occasionally.Get medical attention immediately.

SECTION V :FIRE FIGHTING MEASURES.

Fire : Not considerd a fire Hazard. Explosion: Not considerd a explosion hazard. May release zinc oxide , ammonium

chloride fumes & ammonia & hydrogen chloride gases at very high temperatures.

Existinguishing media: As appropriate for combustibles in Area.

Special Fire fighing instructions: None

Fire Fihgting Procedure: Wear self contained breathing apparatus & protective clothingto prevent contact with skin & clothing.

Flammable limits in air.% by Vol : Not applicable.

Lower : Not applicable.

Upper :not applicable.

SECTION VI: ACCIDANTAL RELEASE MEASURES

Emergency measures:Remove all sources of ignition.Ventillate area of leak orspill.Wear appropriate personal protection equipment as detaled in Section 8.

Method of material containment and cleanup: Clean up in a manner as not to dispersemoisture into air..

Donot allow material to be released to the environment without proper government permits.

Addional information:

Keep unprotected persons away.

See section 7 for information on safe handling.

See section 8 for information on personal protective equipment. See section 13 for disposal information.

SECTION VII :HANDLING & STORAGE

Keep packing tightly closed.

Store in cool ,dry place in tightly closed containers. Ensure good ventilation in work place.

In case of pouring off do-not drw from Mouth.

Store away from oxidising agents.






Protect from exposure to light.

No special requirement for Storerooms.

Keep ignition sources away.

Use rubber or plastic handgloves.SECTION VIII : EXPOSURE CONTROL & PERSONAL PROTECTION:

NOT LISTED AS HAZARDOUS MATERIAL :

AIRBORNE EXPOSURE LIMITS :

No Data

Biological Limit values:

No DataENGINEERING CONTROLS : A system of local & general exhaust is recommended to keep

employee exposure below the airborne exposure limits. Local exhaust Ventlillation is generally

preferred because it can control emission of the contaminant at its source ,preventing dispersionof it into general work area,

Personal protective equipment : Personal respirators (NIOSH APPROVED) :For conditions of use where the exposure to

the dust or mist is apparent a half face dust/mist respirator may be worn.For emergenciesor instances where the exposure levels are not known use a full face positive pressure ,air

supplied respirator.

Skin protection: wear protective gloves like neoprene plastic & clean body covering

clothing.

Eye protection:Use chemical safety goggles and or full face shield where dusting orsplashing of solution is possible.

Maintain eye wash fountain & quick drench facilities in work area.

SECTION IX PHYSICAL & CHEMICAL PROPERTIES

Appearance :Clear green liquid

Color :green

Odour :Characteristic

pH :> 11

Vapor pressure :Not determined

Vapor density :Not determined.

Boiling point /Range >Not determined

Melting Point / :ND

Solubility in water :100%

Specific Gravity NDInformation on Flammable material : Not a Flammable material

Additional information:Not Inflammable & not a FireHazard.

Flash Point :No data

Percent Volatile by Vol : 0

Evoporation Rate :No data

Evoporation Standard : No data

Auto Ignition Temp :Not available






Lower Flammability limit in Air: Not available.

Upper Flammibility Limit in Air :not available.

SECTION X :STABILITY & REACTIVITY Chemical stability :stable

Conditions to Avoid: Moisture, Dusting

Mateials to avoid :potassium cyanide , acids , alkalies.

Hazardous decomposition products: None

Hazardous polymerization :will not occur.

SECTION X1 :TOXICOLOGICAL INFORMATION

Primary irritant effect

On the skin: Irritant to skin & mucous membraines.

On the eyes: Irritating effect. Sensitization: No sensitizing effects known

No mutazenic effects have been observed on tests with laboratory animals.

Additional toxicological information:To the best of our knowledge the acute & chronic toxicityof this substance is not fully known..No classification data on carcinogenic properties of this

Material is available from EPA,IARC ,OSHA Or ACGIH

SECTION XII: ECOLOGICAL INFORMATION

ECOTOXICITY :Not Available.

Persistance & degradability :No Data available.

Mobility :No data availabe

Enviornmental exposure : No data available. Bioaccumulative potential ;No data available.

General notes: Donot allow material to be released to the enviorment without proper govt

permits.

SECTION XIII : DISPOSAL CONSIDERATION:

Reccommended methods for safe & enviorment friendly disposal :Whatever cannot be saved forrecovery or recycling should be managed in an approved & appropriate waste disposal

facility.Processing ,use or contamination of this product may change the waste management

options.dispose of containers & unused contents in accordance with federal , state & lacal

requirements.

SECTION XIV :TRANSPORT INFORMATIONS:

Not a hazardouse material for transportation.DOT regulations

Hazard Class :noneLand transport ADR/RID (Cross border)

ADR /RID class :None.






Maritime transport IMDG

IMDG class :none

Air transport ICAO-IT & IATA – DGR

ICAO/IATA Class :NoneTransport /Additional information

Not dangerous according to the above specifications.

SECTION XV :REGULATIONS.Product related hazard information.

Hazard symbols: Xn harmful.Risk phrases :

37 irritating to respiratory systemSafety phrases:

36/37Wear suitable protective clothing & gloves.

Information about limitation of use:

For use only by technically qualified individuals.

SECTION XVI :INFORMATION.Employers shoud use this information only as a supplement to other information gathered by

them and should make independent judgement of suitability of this information to ensure proper

use and protect the health & safety of employees. This information is furnished without warrantyans any use of this product not in conformance with this material safety data sheet , or in

combination with any other product or process , is the responsibility of the user.

DEPARTMENT issuing MSDS : Lab, Health ,Safety & enviorment department .Contact :P.N.MENON (CEO) SHREE TECH INTERNATIONAL.

521/522 Solitaire Corporate Park BLDG no 5 , Chakala , Andheri (E) Mumbai 400 093 India

Shelf Life :18Months

Documents

MSDS -Polyelectrolyte STI Oriental