1
9. Radio A: REMOVAL AND INSTALLATION 1. RADIO BODY 1) Disconnect ground cable from battery. 2) Remove console box. <Ref. to 5-4 [W1A0].> 3) Remove AT cover (AT model). 4) Remove center panel. 5) Remove fitting screws, and slightly pull radio out from center console. S5M0048A 6) Disconnect electric connectors and antenna feeder cord. 7) Install in the reverse order of removal. 2. FRONT SPEAKER 1) Remove front door trim speaker grille. 2) Remove screws which secure front speaker. 3) Remove speaker and disconnect connector. 4) Install in the reverse order of removal. 3. REAR SPEAKER 1) Remove rear door trim speaker grille. 2) Remove screws which secure rear speaker. 3) Remove speaker and disconnect connector. 4) Install in the reverse order of removal. 10. Keyless Entry System A: REMOVAL AND INSTALLATION 1. KEYLESS ENTRY CONTROL MODULE 1) Disconnect battery ground cable. 2) Remove instrument panel lower cover and knee panel. <Ref. to 5-4 [W1A0].> S5M0044A 3) Remove the two nuts, then remove keyless entry control module (A) while disconnecting con- nector. S6M0481A 4) Install in the reverse order of removal. 17 [W10A1] 6-2 SERVICE PROCEDURE 10. Keyless Entry System

MSA5T0126A27952 - Fores

Embed Size (px)

DESCRIPTION

Forest

Citation preview

Page 1: MSA5T0126A27952 - Fores

9. RadioA: REMOVAL AND INSTALLATION1. RADIO BODY1) Disconnect ground cable from battery.2) Remove console box. <Ref. to 5-4 [W1A0].>3) Remove AT cover (AT model).4) Remove center panel.5) Remove fitting screws, and slightly pull radioout from center console.

S5M0048A

6) Disconnect electric connectors and antennafeeder cord.7) Install in the reverse order of removal.

2. FRONT SPEAKER1) Remove front door trim speaker grille.2) Remove screws which secure front speaker.3) Remove speaker and disconnect connector.4) Install in the reverse order of removal.

3. REAR SPEAKER1) Remove rear door trim speaker grille.2) Remove screws which secure rear speaker.3) Remove speaker and disconnect connector.4) Install in the reverse order of removal.

10. Keyless Entry SystemA: REMOVAL AND INSTALLATION1. KEYLESS ENTRY CONTROL MODULE1) Disconnect battery ground cable.2) Remove instrument panel lower cover andknee panel. <Ref. to 5-4 [W1A0].>

S5M0044A

3) Remove the two nuts, then remove keylessentry control module (A) while disconnecting con-nector.

S6M0481A

4) Install in the reverse order of removal.

17

[W10A1] 6-2SERVICE PROCEDURE10. Keyless Entry System