Upload
gloria-stoney
View
216
Download
0
Tags:
Embed Size (px)
Citation preview
MPSEDC
Madhya Pradesh State Wide Area Network
Madhya Pradesh State Electronics Development Corporation Ltd
(MPSEDC)
• Introduction of MPSWAN• Structure of MPSWAN• POP locations details• Network Diagram• POP Equipment Details• IP Address Allocation
Topics
MPSEDC
Introduction to MPSWAN
• MPSWAN is Madhya Pradesh state wide area Network.
• MP SWAN will create a vertical connect(backbone):- A)-SHQ = 1B)-CHQ=10C)-DHQ=39 D)-BHQ=292
• Horizontal- all department will connect.
• MPSWAN will carry data, voice and video traffic.
MPSEDC
Summery of POP Locations
Name of the MPSWAN POP
No. of the vertical POPsNo. of the vertical POPs Operational
No. of the Horizontal connects operational
SHQ 1 1 152
CHQ 10 10 378
DHQ 39 39 594
BHQ 310 282 286
TOTAL 360 332 1410
MPSEDC
• As per the proposed Network Architecture of SWAN, POPs are divided into four groups:
A).Tier-1 POP--NMC at Bhopal.: 01B).Tier-2 POP -- all Divisional HQ: 10 (Excluding State HQ)C).Tier-3 POP -- all District HQ: 39D).Tier-4 POP -- at Block/Tehsil HQ: 310 .
• Apart from this the proposed SWAN network will be divided into two parts namely:-A). SWAN BackboneB).User Departments Connectivity
• SWAN Backbone will be through conventional lease lines and all MPSWAN backbone lease.
MPSWAN Network
MPSEDC
1-Disel Generator
A). 8KVA capacity B). Fuel consumption check (by dip level or by flow meter ).C).Check fuel tank, battery status
2-UPS
A). Types of UPS :-1-CHQ/DHQ = 6KVA UPS with 2hours backup.2- BHQ= 3KVA UPS with 4-5 hours backup.
B).As above diagram please ensure all are connected.C).Ensure that all batteries are connected.D).for any UPS complaint :- log to Emerson toll free no :-email id.
3-Router: • Router is a device that connects two networks.
A).Router used in MPSWAN network:• SHQ=Cisco 7609 series.• DHQ\CHQ=Cisco 7206 series• BHQ=Cisco 2821 series• horizontal offices=Cisco 2801 & Cisco 1841 series
MPSWAN Equipments Details
MPSEDC
• In Cisco 7206 Six slots are available in Router Front Side.A)-STM Card install in Slot No. 1 and 3
B)-E1 Card install at Slot No. 4
C)-Slot No. 2,5,6 are Vacant for future use.• In Cisco 7206 Back Side 4 Slots are
available:-A)-In slot 0(zero) three Gigabit interface
B)-one fastethernet interface are available.
Interface physical position
MPSEDC
• In Cisco 2821 two Slots are availableA)-In slot zero, two gigabit interface/B)- Two serial interface is install. Serial interface is used for
WAN connectivity.
c)-BRI interface
D)-In slot one, two G.703 port are available. One G.703 port is used connectivity between DHQ to BHQ pop and one is vacant for future use.
Interface physical position
MPSEDC
• Switches are used to connect multiple devices on the same network within a building or campus.
• The data link layer (layer 2) of the OSI model. • Two types of Switch-
A)-Manageable Switch- The switch can be monitored and adjusted locally or remotely to give you control over network traffic. For security we create the VLANs this type of switch.B)-Unmanageable Switch- does not allow you to make changes and Home-networking equipment typically offers unmanaged switches.
• We are use the following Cisco switches-A)-NMC-CISCO-6509B)-POP Room(All)-CISCO 2960
.
4-Switch:-
MPSEDC
• A modem is a communication device that converts binary (digital) signal into analog and analog to binary signals.
• We use One/Two Pairs modem for connectivity-
A-Master modem-Install at BSNL or POP end.
B-Slave Modem- Install at Customer end.
• How to Connect Modem in Network-A)-Both end v.35
B)-Both end EthernetC)-Customer end V.35 and Exchange end G.703
5-Modems
MPSEDC
• IP phone is internet protocol phone.
• full-feature telephone that provides voice communication over the same data network.
• When IP phone is registered, phone displaying the Unique no like 1009 or 1008.
6-IP Phone
MPSEDC
7-PDU(Power Distribution Unit
• PDU reboot abilities for network access to remote sites and data center equipment the Switched POPS Cabinet .•PDU provides per outlet measurements of current, voltage, power (kW), apparent power, crest factor, and power factor.
•SNMP is the most widely used network management solution for our networks.
•It is an open standard-based framework that is simple but yet flexible enough to manage many different types of devices.
8-Simple Network Management Protocol (SNMP)
Alert Pingo With the help of this Tool we can Monitor our POP
network equipment and Horizontal Client.o Fill the IP address of horizontal and also
description.
Use of Ping Ping is a first command to check Network
connectivity. If we phase a problem in our Network then we use ping command to check connectivity.
First we ping Gateway means ip configure at router gigabit port those are connect to switch.
If we get proper response of our gateway means problem is not local end, after that we ping our next hop ip(If we check network from BHQ then next hop ip is DHQ wan ip , if we check network from DHQ then next hop ip is CHQ wan ip and If we check network from CHQ then next hop ip is SHQ wan ip .
An IP address is a 32-bit number that uniquely identifies a host (computer or other device, such as a printer or router) on a TCP/IP network.
IP addresses are normally expressed in dotted-decimal format, with four numbers separated by periods, such as 192.168.123.132.
IP address
MPSEDC
Class Leftmost bits Start address Finish address
A 0xxx 0.0.0.0 127.255.255.255
B 10xx 128.0.0.0 191.255.255.255
C 110x 192.0.0.0 223.255.255.255
D 1110 224.0.0.0 239.255.255.255
E 1111 240.0.0.0 255.255.255.255
IP Address Classification
MPSEDC
We are using two IP pools 10.124.x.x/16 and 10.125.x.x/16 in our network.
From these pools ip has been created for all horizontal and verticals location.
For ex. Gwalior district block IPs and department IPs has been allotted as follows:-
MPSEDC
Gwailor DHQ - IP Schema
Sr. No.
Tehsil/Sub
Division/ Block name
WAN IP Subnet
connecting to SHQ/DHQ (E1
Link) /30
WAN IP Subnet
connecting to CHQ/BHQ
(E1 Link) /30
PTP Connectivity
for Horizontal/3
0
Total PTP
Network for
Horizontal
Gigaethernet port Port IP
of Router
Switch IP address
BHQ Off RF/LAN IP address Range
allocated /25
1 Gwalior 10.124.86.1 10.124.86.2
10.124.86.4 &
10.124.87.0127 10.124.88.1 10.124.88.2 10.124.88.0/24
2 Ghatigaon 10.124.89.110.124.89
.210.124.89.
431
10.124.89.129
10.124.89.130
10.124.89.128
3 Dabra 10.124.90.110.124.90
.210.124.90.
431
10.124.90.129
10.124.90.130
10.124.90.128
4 Bhitrarwar 10.124.91.110.124.91
.210.124.91.
431
10.124.91.129
10.124.91.130
10.124.91.128
5 Chinar 10.124.92.110.124.92
.210.124.92.
431
10.124.92.129
10.124.92.130
10.124.92.128