Upload
erik-stojanovic-kocjancic
View
674
Download
9
Embed Size (px)
DESCRIPTION
Atomic XTO ski binding mounting instructions
Citation preview
2 3
4 6
7
5
8 9
NO OK
To be mounted by a ATOMIC Authorized dealer only.
ALP
INE
BIN
DIN
GS
MOUNTING1. Insert the Thin Plate in the seating ahead the
plate (�g. 1).2. Place it correctly with a rotational motion
(�g. 2).3. From the rear, slide the Toe piece on the
interface until it corresponds with or is just above your boot sole length using the manual lock to authorize the sliding (�g. 3 & 4).
4. From the rear, slide the Heel piece on the interface until it corresponds with or is just above your boot sole length using the manual lock to authorize the sliding (�g. 5).
5. Mount the Brake following the usual procedure (�g. 6).
ADJUSTING EXAMPLE6. Identify the length of the boot.7. If you have boot sole L 306 mm, adjust the Toe
on the 308 mm mark. The range in this case is 301 mm to 308 mm
(�g. 7).8. If you have chosen the L 306 mm, adjust the
Heel piece on the 312 location. The range in this case is 305 mm to 312 mm
(�g. 8) .9. Step in the boot and check forward pressure
(�g. 9) . The arrow on the housing must be within the
scribed area.
CONTENTS OF THE BOX› 2 Toes mounted on a sliding part› 2 Heels mounted on a sliding part› 2 Brakes› 2 Thin Plates› 1 Notice
MOUNTING & ADJUSTING
XTO 614, XTO 412, XTO 310
SMARTRAK
MOUNTING SMARTRAK
1