Upload
nunofos
View
78
Download
3
Embed Size (px)
Citation preview
© www.tacho-designs.de © 1
Mounting guidelines heating covering Corsa B, Tigra, Combo
For more accesories visit our website www.tacho-designs.de
1. general information
The following information are without engagement. We are not responsible for damages rsutling from this modification.
2. Demounting
First remove the throttle for the vantilation with a slotted screwdriver.
Afterwards remove the covering around the throttle for the ventilation with a slotted screwdriver....
...and unscrew the screws which are located behind this covering.
© www.tacho-designs.de © 2
Now take two timber wedges or slotted screwdrivers and revolve the ventilation diffuser over its lock to the bottom.
Behind the ventilation slot there are two screws in the corners which have to unscrewed. Afterwards you should be able to remove the whole display covering togther with the display.
Next thing to do is removing the adjusting knobs. The left and the right one can be removed by pulling them forward. To remove the one in the middle you have to push down a lever with a screwdriver.
Meanwhile you should be able to pull the whole heating unit forward. But you still have to push down some nibs bevor you can remove the front part of the heatong. The first, second and third are on the heating unit (picture left).
© www.tacho-designs.de © 3
Two more screws can be found on the left and on the right side of the heating unit.
Now you should be able to remove the front part of the heating so that you can see something similar to the picture left. The only thing left to do is change the two lamps with your new leds. Check wether both leds work properly. If one does not, just turn around the socket. If everything works properly, you can reassemble the whole heating and you are ready.
Have a good trip.