Upload
dangdang
View
220
Download
5
Embed Size (px)
Citation preview
Norcros Adhesives, Harewood Street, Tunstall, Stoke-on-Trent, Staffordshire, ST6 5JZ Tel: +44 (0) 1782 524140 www.norcros-adhesives.com
MOULD RESISTANT SILICONE
High Modulus Acetoxy Silicone Sealant
25% Flexibility Factor Mould Resistant Interior & Exterior Quick Drying Conforms to BS 5889(B) & ISO 11600
A high modulus acetoxy curing silicone sealant containing a powerful anti-fungal compound to prevent mould growth in areas of high humidity.
Details Performance
Movement accommodation ± 12.5% EN15651-1
Skinning time 5 minutes @ 20oC
Cure time 2mm per 24 hours
Hardness (Shore A) 15-25
Application temperature resistance +5oC to +40oC
Service temperature resistance -30oC to +150oC
Tensile strength 1.5 MPa DIN53504
Stress 0.2MPa at 100% elongation DIN53504
Specific Gravity ~1.00 g/cm3
Cleaning Uncured sealant: white spirit Cured sealant: preparatory silicone digester
Minimum joint width 4mm
Maximum joint width 25mm
Joint ratio Maximum depth 50% of joint width
Coverage per C3 cartridge Approx. 11 linear metres for a 6mm bead
Elongation at break >400% DIN53504
Specific Data
Norcros Adhesives, Harewood Street, Tunstall, Stoke-on-Trent, Staffordshire, ST6 5JZ Tel: +44 (0) 1782 524140 www.norcros-adhesives.com
General Surface Preparation All surfaces should be dry, clean and dust free. All loose or flaking surface coatings and old sealant should be removed before application.
Application Cut the tip off the cartridge taking care not to damage the thread. Apply nozzle and cut cleanly at an angle of 45o with an opening slightly larger than the gap to be sealed. Fill deep gaps with a suitable expanding foam. When applying to plastic & acrylic baths, fill the bath half full with water until the sealant has dried and cured. Apply using a standard sealant gun. Best results will be obtained by maintaining an even pressure on the gun trigger and keeping the gun at a con-stant angle to the surface being sealed. Smooth down within 10 minutes of application using a spatula, piece of wood or close textured sponge wetted with a soap and water solution. An improved appearance can be achieved by placing masking tape to both sides of the joint and removing within 5 minutes of application.
Storage Store in dry internal conditions away from direct sunlight between 5-25oC. The product has a 12 month shelf life from date of manufacture. Technical Advice For advice on tile installation products call Norcros Technical Helpline on 01782 524 140
MOULD RESISTANT SILICONE
Areas of Use Limitations
Sealing around all types of bath & shower trays
Expansion joint and corner joint sealing of ceramic & porcelain tiles
Sealing around sanitary fittings in domestic & municipal applica-tions
General sealing in areas subject to high humidity levels
As an adhesive on cosmetic bath & shower trim
Not suitable in food preparation areas
Do not use in conjunction with bitumen or asphalt
Not suitable for use in aquaria
Not suitable for use with natural stone products
Not suitable with certain metals, e.g. copper, lead