Mothers Choice Loop Stroller

Instruction Manual & User Guide Loop Stroller

An IGC Dorel brand

Please read this manual in its entirety before assembling the product and follow all instructions contained herein.

Please retain instruction manual for future reference.

Illustrations are representative only. Design and style may vary.

Instruction Manual & User Guide

2 #9931 – Loop Stroller – 11-09.

Warnings These instructions detail the safe use, assembly and maintenance of the stroller. Please read these instructions carefully

and ensure that they are followed at all times:

• Check that the stroller is fully erected and that all safety locks are engaged before placing a child in the

stroller.

• Do not allow children to stand on the seat or footrest.

• Do not attempt to lift the stroller by the bumper bar or child tray.

• Do not carry extra children or bags on this stroller, unless in an approved accessory.

• Do not leave children unattended.

• Do not run or jog with this stroller.

• Do not use on stairs or escalators.

• Do not use the stroller near an open fire, barbecue or exposed flame.

• Engage front wheel swivel lock, to lock front wheel(s) when travelling on rough or uneven surfaces.

• Follow the manufacturer’s instructions at all times.

• Make sure children are clear of any moving parts if you adjust the stroller, otherwise they may be injured.

• Not recommended for a child under six months old.

• Please ensure that the safety harness is adjusted firm to the child’s body but comfortably and used at all

times.

• Put on all the brakes whenever you park the stroller.

• Shoulder straps must be unclipped whenever waist strap buckle is unfastened.

• This product is not intended for commercial use.

• To avoid danger of suffocation, keep any plastic bags away from babies and children. Do not use plastic bags

in cribs, beds, carriages or playpens. Plastic bags can block nose and mouth and prevent breathing. Bags are

not toys. Please dispose of waste packaging thoughtfully.

• Use only those accessories which are supplied by IGC Dorel, and approved for use with the stroller.

The weight of the child using this stroller should not be more than 17kg.


#9931 – Loop Stroller – 11-09. 3

Component list

Hood frame

Folding lever

Tray

Seat

Footrest

Front brake

Handlebar

Canopy

Handle reverse

button

Harness buckle

Rear brake

Storage latch

(not pictured)

Front wheel swivel

lock

Wrist tether strap (not shown)


4 #9931 – Loop Stroller – 11-09.

Assembling your Loop Stroller

TO OPEN THE STROLLER • Remove the security tie if the stroller has one.

• Position the stroller with the wheels or wheel posts on the

floor.

• Disengage the storage latch, as per Figure 1.

• Grip the handle and lift upwards, as per Figure 2, until the

frame is securely locked in the open position.

Figure 1 Figure 2

TO ATTACH THE FRONT WHEELS • Lay the stroller on its back.

Push inside the post to ensure that the retaining pins have popped

out, as per Figure 3.

• Align the hole on the top of the wheel with the retaining pins on the seat posts.

• Push in. You will hear a ‘click’ when the retaining pins have popped out.

The wheels are locked into place.

To remove a front wheel, lay the stroller on its back, press the

retaining pin with a pen tip, and pull the wheel assembly.

Figure 3

Retaining pin


#9931 – Loop Stroller – 11-09. 5

Assembling your Loop Stroller (cont.) TO ASSEMBLE THE REAR WHEELS

• Slide a washer onto the end of the axle assembly, then the single wheel (brake cogs first), and then another

washer.

• Stick the cotter pin through the end of the axle assembly.

• Push the hub cap over the spokes of the wheel, until you hear a ‘Click’. Repeat for the other wheel.

Figure 4

TO ATTACH THE REAR WHEELS • Lay the stroller on its front.

• Align the rear wheel assembly to the rear wheel posts so the red brake levers are

pointing towards the rear of the stroller, as per Figure 5.

• Push the rear wheel assembly onto the rear wheel posts.

The wheel assembly is locked into place when the retaining pins pop out.

To remove the rear wheels, lay the stroller on its front, press the

black retaining pin firmly, pull out that end of the wheel assembly,

and repeat for the other side.

Figure 5

TO ATTACH THE CANOPY • Secure the ‘C’ clamps on the canopy to the frame on either side of the seat.

• Zip the inside of the canopy to the top of the frame.

• Velcro to the top of the seat.

Washer

Hub cap

Cotter pin

Single wheel

Washer


6 #9931 – Loop Stroller – 11-09.

Assembling your Loop Stroller (cont.)

TO LOCK THE FRONT SWIVEL WHEELS

• Turn the front wheels so that their small black tabs

are pointing directly ahead.

• Lift the black tabs so that they clip into their

groove, as per Figure 6.

To unlock the front swivel wheels, push

down on the small black tabs on each

wheel, as per Figure 7.

Figure 6 Figure 7

TO APPLY THE BRAKES • Press down firmly on the red levers beside each rear wheel, as per Figure 8.

• Press down firmly on the long black levers on the front wheel set.

To release the brakes, lift the brake levers firmly.

Figure 8

TO LOWER THE BACKREST • Lift the adjustment lever on the rear of the seat.

• Lower the backrest to the desired position as per Figure 9.

To raise the backrest to the sitting position, move the backrest

upwards.

Figure 9

TO EXTEND THE CANOPY • Push the front centre of the canopy forward.

To retract the canopy, pull the front centre of the canopy backwards,

as per Figure 10.

Figure 10


#9931 – Loop Stroller – 11-09. 7


TO FIT THE TRAY • Align and insert the locator pins into the tray’s mounting holes.

• Push the tray in. It will click.

To remove the tray, press the buttons on the underside of the tray on

both sides as per Figure 11, and pull.

Figure 11

TO EXPOSE THE VIEWING WINDOW • Push the canopy all the way forward.

• Pull the viewing window cover away from the Velcro® loops.

• Rollback the cover into a tight bundle.

• Wrap the plastic toggle at the rear centre of the canopy over the bundled cover

and through the elastic loop.

TO FOLD THE STROLLER • Close the canopy.

• Raise the backrest to the sitting position.

• Remove any items in the basket.

• Unlock the swivel wheels and apply the brakes.

• Locate two red latches inside the canopy, on the

inner frame beneath the Velcro® flaps on each

side.

• Grip both red latches and pull them up at the same

time, as per Figure 12.

• Push the handle downwards until the stroller is

folded, as per Figure 13.

• Engage the storage latch.

Do not attempt to lift the stroller by the

child tray.

Figure 12 Figure 13


8 #9931 – Loop Stroller – 11-09.


TO REVERSE THE HANDLE • Press the silver button marked with ‘PRESS’ on the

left handle, as per Figure 14.

• Swing the handle forwards or backwards, as per

Figure 15.

• Ensuring it locks into place prior to using.

Figure 14 Figure 15

TO ATTACH AND USE THE WRIST TETHER STRAP Correct use of the wrist tether strap will prevent stroller runaway and

consequent injury to the stroller occupant.

• Attach the tether strap to the stroller by wrapping the small loop end of the

tether around the handle, feeding the large loop end through the small loop and

pulling tight, as per the illustration.

Whenever a child is in the stroller and brakes are not engaged, the

large loop should be around your wrist.

TO SECURE YOUR CHILD A five point harness is provided to secure the child.

• The harness straps can be adjusted by moving each strap’s slider.

• The buckle is released by squeezing the buckle tongues together.

WARNING: Ensure shoulder straps are unclipped

whenever waist strap buckles are unfastened.


#9931 – Loop Stroller – 11-09. 9


10 #9931 – Loop Stroller – 11-09.


#9931 – Loop Stroller – 11-09. 11


12 #9931 – Loop Stroller – 11-09.

Product care and maintenance • Always store the stroller in a clean and dry place.

• Clean the frame by wiping with a damp cloth.

• Do not use abrasives, bleach or strong detergents.

• Spot clean fabrics with warm water and mild soap.

• Ensure fabric is dry before storing.

• Occasionally clean and lubricate wheels and axles with light lubricating oil.

• Regularly check for loose parts and tighten when required.

• Damaged or broken parts should be replaced.

Customer service Please contact our Customer Service Department if you experience a problem with this product or require assistance:

AUSTRALIAN CUSTOMERS

NEW ZEALAND CUSTOMERS

Email [email protected] [email protected]

Web www.igcdorel.com.au www.igcdorel.com.au

Phone 1 (03) 8311 5300 (09) 276 1040

Phone 2 1300 809 526 (local call cost) 0800 628 000 (Toll Free)

Hours 8:30 am – 4:30 pm, Monday to Friday 9:00 am – 4:00 pm, Monday to Friday

Postal IGC Dorel Pty Ltd P.O. Box 1260 Sunshine West, Victoria, 3020 Australia

IGC Dorel (New Zealand) P.O. Box 82377 Highland Park Mt Wellington New Zealand

Guarantee This product carries a twelve month guarantee to rectify manufacturing defects. It does not cover problems arising from

accidental damage or product misuse. Specifications are subject to change without notice.

Copy or reproduction without permission is prohibited.

© 2009 IGC Dorel Pty Ltd. All Rights Reserved. www.igcdorel.com.au

Documents

Mothers Choice Loop Stroller