MONSTER CONTROL CENTER - Assembly Instructions Page 2.WHAT
YOU'LL NEED: Scissors, Elmer's glue or a glue stick, and a ruler or
other straight-edge.
FOLDING TIP: I recommend 'scoring' the fold lines before
folding. You can use an old ink pen, a knitting needle, the end of
a paper clip, or any metal object that will make a crease on the
fold lines without tearing the paper. Scoring will help you fold
much more quickly and precisely.BUILDING TIP: For a nicer looking
model, darken the fold lines and paper edges with a black marker.
ASSEMBLY: Begin by cutting out BOX A on Parts Page 1. Fold all four
tabs DOWNWARD and then fold DOWNWARD between all five panels. Glue
tab 1 to the back of the opposite panel, as shown in Figure 1. Then
glue tabs 2, 3 and 4 to the inside of the box as shown in Figure
2.
Cut out BOX B on Parts Page 1 and BOX C on Parts Page 2.
Assemble these two boxes in the same manner as we did with BOX A.
Glue all three boxes together as shown in Figure 3.
Next, cut out the FRONT PANEL on Parts Page 2. Fold the two side
panels DOWNWARD, folding along the blue lines. Place the FRONT
PANEL over the front and sides of the boxes, as shown in Figure 4.
Glue the side panels (but NOT the front panel) to the boxes.
Now cut out the BACK PANEL on Parts Page 3. Fold the flap
DOWNWARD and then fold the top panel DOWNWARD, folding along the
blue lines. To position the BACK PANEL properly, slide the flap in
between the FRONT PANEL and the front of the boxes, as shown in
Figure 5. Then glue the BACK PANEL to the back of the boxes as
shown in Figure 6.
Cut out the CONTROL BOARD on Parts Page 4. Fold the back panel
DOWNWARD, fold the two tabs DOWNWARD and then fold the two end
panels DOWNWARD, folding along the blue lines.Glue the tabs to the
back panel, forming a wedge-shaped piece as shown in Figure 7.
Position the CONTROL BOARD as shown in Figure 8 and glue the
CONTROL BOARD's back panel to the front of the boxes.
To finish the project, cut out the SIGN on Parts Page 4. Fold
the two outer panels UPWARD, folding along the green lines. Then
fold DOWNWARD along the blue center line. Glue the two inner panels
together, forming a T-shaped piece as shown in Figure 9. Trim if
needed. Position the SIGN on the top of the boxes as shown in
Figure 10 and glue the SIGN in place.
Your Monster Control Center is now complete and ready for
use!
