Model and Diagrams © Dennis Walker

Open

out

Repeat last two steps on

right side and open out

entirely

Page 1 of 4

Page 2 of 4

Model and Diagrams © Dennis Walker

Make 3D

A

B

During assembly, B goes OVER A (i.e. A

goes inside B). Note that the far edge of

B can be used to hold down the folds

under the flame/petal

Tuck this under the edge

underneath.

The white part of the A

flame/petal goes under

the coloured part of the

B flame/petal.

AB

Starting point for

Double Flame

Variation of Open Flame. Uses same body.Model and Diagrams © Dennis Walker

Fold Open Flame Lid up to and including the diagram marked

Fold and unfold. Top Layer only

Make 3D

Page 3 of 4

Separate layers

(pull paper from behind)

Lift Top Layer to form first flame/

petal using existing creases.

Allow it to curve.

Squash the flap. The valley

fold indicated lies along the

centre line underneath.

Fold flap under

Soft petal fold

X 5

Assembly similar to

Open Flame

Model and Diagrams © Dennis Walker

(Note: Unconfirmed suspicion that this may be an independent discovery of a base by Tomoko Fuse)

Add the pinch marks shown

One unit complete

Page 4 of 4