12 Days of Christmas ©Angie Kennedy Juda All rights reserved. Page 1

#3 Merry & Bright Treat HolderInstructions ©Angie Kennedy Juda

www.mychicnscratch.com

12 Days of Christmas ©Angie Kennedy Juda All rights reserved. Page 2

Supplies (All supplies Stampin’ Up! unless noted.)

• Stamps: Merry & Type Stamp Set W#122550 or C#122552

• Ink: Cherry Cobbler Ink #119669, Lucky Limeaid Ink #122935, Pear Pizzazz Ink #119784

• Card stock: Pear Pizzazz CS #119795, Riding Hood Red CS #111348, Whisper White CS #124302, Letters to Santa DSP #122349

• Accessories: Scallop Square Die #115950, Perfect Polka Dot Embossing Folder #117335, Simply Scored Scoring Tool #122334, Word Window Punch #119857, Snail Adhesive #104332, Decorative Label Punch #120907, 1-3/8 Square Punch #119877, Crop-a-Dile #108362, Sponges #101610, Dimensionals #104430, Rhinestones #119246, Big Shot Die Cut Machine #113439

• Ribbon: Old Olive Taffeta Ribbon #111368

Cutting Measurements• Pear Pizzazz: scrap large enough for two Scallop Square Die cuts.

• Whisper White: scrap large enough for sentiment stamp.

• Riding Hood Red: Scrap large enough for Decorative Label Punch.

• Letters to Santa DSP: 12 x 1-1/2

12 Days of Christmas ©Angie Kennedy Juda All rights reserved. Page 3

I hope you enjoy the Merry & Bright Treat Holder!!

Instructions

Please read instructions all the way through before you begin.1. Cut two scallops from the Pear Pizzazz Card Stock using the Scallop Square Die.

2. Emboss the two Pear Pizzazz scallops using the Perfect Polka Dot Embossing Folder.

3. Score the scallops at 3”, fold them on the score line, then trim off the scallops along the scored edge.

4. Punch a window centered near the top of both pieces of the treat holder using the Word Window Punch.

5. Adhere the bottom flaps of the treat holder together using Snail Adhesive. Sponge the edges with Pear Pizzazz ink.

6. Stamp Merry & Bright sentiment onto Whisper White card stock using Cherry Cobbler ink along the top portion of the stamp, and Lucky Limeaid ink along the bottom portion. Punch out stamped image using the Decorative Label Punch.

7. Punch out a label using the Decorative Label Punch and Riding Hood Red card stock. Cut the label in half and trim off the square edges. Use Snail Adhesive to attach each half to the back of the punched sentiment.

8. Feed the Letters to Santa DSP strip through the treat box handles.

9. To create the points use the 1-3/8 Square Punch.

10. Line up all edges of the treat box and punch two holes near the top of the treat bag. Use the smaller side of the Crop-a-Dile tool for this step.

11. Thread the Old Olive Taffeta Ribbon through the holes from front to back and tie a decorative bow. Trim the ends of the ribbon.

12. Attach sentiment to the front of the treat box using Dimensionals.

13. Add Rhinestones to the top and bottom of the stamped image.

14. Your Merry & Bright Treat Holder is complete ....Enjoy!