MAMBA Flash Hole DeburrerCut away the burr on the inside of the
flash hole & drill the flash hole to a uniform size
Ÿ Most manufacturers punch the flash hole through the cartridge
case;
Ÿ To ensure a consistent flash and ignition of the propellant
these burrs must be removed mechanically.
Ÿ This often causes burrs to remain on the inside of the case,
which in turn, causes uneven spread of the primer flame and
subsequently an uneven ignition of propellant;
Ÿ Use the MAMBA Flash Hole Deburrer to cut away the burr on the
inside of the flash hole & drill the flash hole to a uniform
diameter of 2.0mm;
Ÿ As soon as the cutter turns freely without resistance, the
burr will be removed - usually after 2 to 3 turns;
Ÿ If necessary, adjust to cut a little deeper. Be careful not to
go too deep - we only wish to remove the burrs.
Ÿ Insert the deburring tool though the case mouth and locate the
flash hole;Ÿ Slide the guide into the case mouth and tighten;Ÿ Turn
the tool to cut away any burrs;
Ÿ It adjusts/locks easily with one hand without extra tools;Ÿ
The cutter is an engineering grade SOMTA High Speed Steel central
drill bit
that will retain its sharp cutting edges for a long time.
Ÿ The MAMBA Flash Hole Deburrer is all-metal;
Page 1
