Upload
danny-nicholson
View
1.094
Download
0
Embed Size (px)
DESCRIPTION
How to use a lumens visualiser on your interactive whiteboard - a how to guide
Citation preview
Lumens Visualiser Guide
The visualiser allows you to display anything that you put below its camera as a large image on your Smartboard. You can also capture these images to use later.
On the front of the visualiser are the following buttons. Similar buttons can be found on the remote control.
Zoom in
Power on/off
Capture image
Zoom out
To auto-focus, click on the white buttons on the head of the visualiser.
Software
The visualise software is called See II, you should find an icon for it on your desktop
When you run it, you may not see the image from your visualise straight away. You might need to click the “Real Time” button at the top of the screen first.
Save/Load View in real-time
Capture an image – save as a jpg file
Record a video
Control the visualiser and adjust the image
Annotation tools such as lines and arrows
View in full screen mode.
If you cannot see your image
1. Check that the visualiser is turned on (light is on) Press and hold the power button on the front of the visualise to turn it on.
2. Check that the software is in real time mode – click on the “Real Time” button.
3. Check that the visualiser cable is correctly plugged in to a USB port on your computer.
Annotating on top of an image you are showing.
On a Smart Board simply pick up a pen and start writing. The screen image will freeze.
When you are done – to clear the screen click on the red cross in the top corner
If you want to keep your image and notes, click on the camera icon in the top corner instead. This will put a snapshot of the screen into Smart Notebook.