Quick Setup Guide

VeriFone VX 680 3GLong Range Wireless

Startup

The first step is to charge the battery. It is recommended to charge the battery for 6 hours on initial charge for optimum battery performance and life expectancy. Subsequent charge times should average 2.5 hours. You can use the VX 680 while the battery is being charged, however it will not be portable due to the physical electrical connection.

The battery is located on the back of the VX 680 and is installed by aligning the 2 plastic tabs and then pushing down on the very bottom of the battery until you hear a click.

Removal of the battery requires the tab indicated below to be pushed in while lifting up on the battery itself.

Quick Setup Guide

Battery Information

Battery Tab

To charge the battery you connect the power supply to the side of the VX 680 as indicated below.

Charging the Battery

Startup

Quick Setup Guide

Startup

Quick Setup Guide

Loading the paper roll is a simple drop in process. You lift up on the tab built into the paper roll cover and drop in a new roll of paper as indicated below.

Loading the Paper

Startup

Quick Setup Guide

Turning Your Terminal On/Off

Sim Card Information

POWER ON

POWER OFF

POWER SAVE

Please note the VX 680 Long Range is shipped pre-configured and with the carrier 3G Sim card installed.

Coverage Maps

Rogers (GSM/EDGE) rogers.com/business/on/en/smallbusiness/rogers/coverage/

Telus (3G)telus.com/en/on/mobility/network/coverage-map.jsp

Each of the carriers offer coverage maps on their websites which may help in determining what will work in your area.

Press and hold the red button for 7 seconds.

After 3 hours of inactivity the terminal will SHUT DOWN to save the battery. POWER ON the terminal to resume.

After 2 minutes of inactivity, the terminal will enter a SLEEP MODE: The First Data logo will be displayed on the screen. Simply press the green button to resume.

Press and hold the green button for 7 seconds.

Quick Setup Guide

3G Settings

You can view the 3G signal strength in two manners:

GPRS

A On the CommServer main menu.

In this example, the 3 blue bars indicate a signal quality in the 50-75 % range and the blue rings around the top of the tower indicate the device is communicating.

B By accessing the Information page by pressing the button located on the bottom left of the CommServer main menu.

You can cycle through the CommServer information by pressing the key. The signal quality can be found on the second page.

APN:jaspermo.apn

Model: HSCTPHSB

Connected: Yes

Battery: 92%

Network: UMTS

Signal Quality: 57%

Carrier: ROGERS

Determining the 3G Signal Strength

3G signal strength is determined by the coverage each specific 3G carrier provides in any given location. Unfortu-nately all carriers suffer from areas of poor signal strength with some of the causes being:

Distance from cellular (3G) tower

Geographical obstacles (hills/valleys)

Environmental obstacles such as concrete walls, build-ings, basements, elevator and other devices that use the same frequency.

VX680-3G-QSG-2014-10-01 (English)

© 2014 First Data Canada, Ltd. All Rights Reserved. First Data Canada Ltd. is a registered ISO/MSP of Wells Fargo Financial Corporation Canada, Toronto, ON, Canada. All trademarks, service marks and trade names used in this material are the property of their respective owners. All rights reserved

www.firstdatacanada.ca