Upload
others
View
10
Download
0
Embed Size (px)
Citation preview
1. Covering the COVERBOARD with Patterned Paper
Either Chipboard (2 sheets taped
together) or 1 sheet of Mat Board for each of the front and back
covers
BACKSIDE OF Patterened Paper (not included)
Trim (or Miter) corners at an angle. Remain about 1/16th inch from the
corner of the coverboard
Using 2 sided tape , fold the patterned paper over the edges of the
coverbaord and attach
View of the inside of the front and
back covers - you should have 2
pieces that look like this
2. Folding Spine and Attaching Coverboard The spine is scored every one inch,, but before folding like an accordian, ease the scores by folding slightly. Fold toward the bump. (bump on the inside
After easiong scores as noted above, fold like an accordian fold (mountain/valley/mountain).
then lay on table in front of you with the mountains facing up on the ends.
Mountain Valley
Apply 2 sided tape to panels 2, 4, 6, 8 and 10.Apply tape closer to the valley of the fold.
Pane
l 2
TAPE
Pane
l 4
TAPE
Pane
l 6
TAPE
Pane
l 8
TAPE
Pane
l 10
TA
PEFold the spine, like an accordian, so Panel 2 attaches to Panel 3,
Panel 4 to Panel 5, Panel 6 to Panel 7, etc...
After folded and the panels are attached together, this is the TOP VIEW if you hold onto it with the 2 SINGLE
Panels (panel 1 and Panel 12) at each end.
Pane
l 12
TA
PE
Pane
l 1
IF DESIRED LOOK - miter the corners of the panels. Starting with Panel 1
Pane
l 1
AFTER ALL Panels are
Mitered
Panel 1Panel 12
APPLY 2 Sided to Panel 1 - on the outside. This will
attach to the cover
ATTACH PANEL 1 to the inside of the BACK COVER. Flatten the spine and APPLY 2 Sided Tape to the outside
of PANEL 12
Pane
l 12
with
2 S
ided
Ta
pe a
pplie
d
Pane
l 1
Two different views Above: The spine is
fl attened. To the Right , View is of back side of
the folded spine
LINE UP the corners of the 2 covers and attach the FRONT COVER to
the tape on Panel 12
www.
thepa
percu
t.com
www.
pape
rcrea
tions
.com
LIBRARY POCKET BOOK KIT ASSEMBLY INSTRUCTIONS
LIBRARY POCKET BOOK KIT
3. VIEW OF BOOK AFTER COVERS are ATTACHED TO SPINE
4. Covering the COVERBOARD with Patterned Paper
INSIDE VIEW
TOP VIEW
VIEW OF SPINE OF BOOK AND COVERS
5. ATTACHING THE ASSEMBLED LIBRARY POCKETS
Using 2 Sided Tape, attach Cardstock, Text Paper or
Patterned Paper to the iside FRONT and BACK
COVERS. This is done to cover up the coverboard
that is showing
Inside BACK COVER - alreadycovered
Inside FRONT COVER
Using 2 Sided Tape, ATTACH Library Pocket
to the INSIDE of the FRONT COVER.
NOT SHOWN - attach a Library Pocket to the
INSIDE of the BACK COVER also.
Using 2 Sided Tape, ATTACH Library
Pocket to the FIRST SPINE PIECE
APPLY 2 Sided Tape to the BACK of the Library Pocket that is attached to the first Spine piece.
Attach NEXT Library Pocket to the BACK of the one attached to the spine piece
x x x 2 Sided Tape x x x
x x x 2 Sided Tape x x x x x x 2 Sided Tape x x x x x x
2 S
ided T
ape
x x x
VIEW of Library Pockets ATTACHED BACK TO BACK to the SPINE PIECE.
REPEAT WITH ALL 5 SPINE PIECES that
face the inside of the book.
BASICS OF ATTACHING POCKETS:
Do not attach pockets flush with the valley folds of the Spine
- remain about 1/8th inch from the score in the valley fold.
HOWEVER, do not come out too much or pockets will stick out
beyond the cover.
12 Pockets:2 are attached to the inside of
the front and back covers10 are attached BACK TO BACK to the 5 Spine Pieces that face
the inside of the book.