Instruction Learning function 508 cubix / orbit Seite 1 / 2

HBC-radiomatic GmbH Haller Strae 47-53 74564 Crailsheim Learning_function-508-cubix_orbit

2007-08-28

Learning function 508 cubix 1. Open the receiver. 2. Press the "Learning"-button in the receiver for approx. 10 seconds until the LED

"TOK A" illuminates. All transmitter data in the receiver are thereby deleted and the receiver can be taught by a spare transmitter.

3. Make the receiver voltage-free for approx. 10 seconds.

4. Switch the spare transmitter on:

Press button in the second step and release the button.

Press STOP button in the second step and release the button.

Press button in the second step and release the button.

The transmitter is ready to operate when the LED on the transmitter blinks green.

Important note: It must be ensured that the transmitter has not already been assigned to another receiver.

5. Press the button on the transmitter for approx. 10 seconds in the first step, until the transmitter indicates with an intermittent beep that it is in learning mode. Release the button again.

6. Press the Learning"-button in the receiver until LED "TOK A" flashes 3 times and the intermittent beep stops. Release the button again.

The transmitter indicates with a beep that a receiver is assigned (only transmitters with TC-modules).

7. Switch the transmitter off. 8. Make the receiver voltage-free for approx. 10 seconds. 9. Carry out a function test. 10. Mark the spare transmitter with e.g. the crane or system number to enable a

positive allocation. Please inform HBC-radiomatic GmbH that this has been carried out.

"Learning"-button in receiver 508

LED TOK A

Instruction Learning function 508 cubix / orbit Seite 2 / 2

HBC-radiomatic GmbH Haller Strae 47-53 74564 Crailsheim Learning_function-508-cubix_orbit

2007-08-28

Learning function 508 orbit (as from software V1.5) 1. Leave the receiver be connected to supply voltage while opening the lid. 2. Press the "Learning"-button in the receiver for approx. 10 seconds until the LED

"TOK A" illuminates briefly. All transmitter data in the receiver are thereby deleted and the receiver can be taught by a spare transmitter.

3. Make the receiver voltage-free for approx. 10 seconds. Important note: It must be ensured that the transmitter has not already been assigned to another receiver.

4. Press buttons K1 and K2 (see transmitter layout below) at the same time, while you switch on the transmitter. When the transmitter indicates with an intermittent beep that it is in learning mode, release the buttons again.

5. Press the "Learning" button in the receiver for approx. 6 seconds until LED "TOK A" flashes 3 times. Important note: While doing this procedure the transmitter must be in learning mode condition (see pt. 5).

6. Switch the transmitter off. 7. Make the receiver voltage-free for approx. 10 seconds. 8. Carry out a function test. 9. Mark the spare transmitter with e.g. the crane or system number to enable a

positive allocation. Please inform HBC-radiomatic GmbH that this has been carried out!

"Learning"-button in receiver 508

LED TOK A