Upload
truongnhu
View
218
Download
1
Embed Size (px)
Citation preview
Calibration andInstrumentation
Technician
Courses
Stanislaus County Area
Joint Apprenticeship Program&Manufacturing
Maintenance
The Calibration and Instrumentation Technician Apprenticeship Program is designed for individuals hired as new apprentices by member employers of the Stanislaus County Area Manufacturing and Maintenance Joint Apprenticeship Committee. The program is composed of 576 hours of classroom and lab instruction and 8,000 hours of on-the-job training and is approximately 4 years in length. The program is designed so that the employer hires the apprentice, and the apprentice increases his/her occupational skills and knowledge through On-The-Job Training (OJT) at the employer site while attending specific college courses approved as related supplemental instruction (RSI) at Modesto Junior College. Students interested in more information about the program should contact the MJC Technical Education Office for a listing of member employers.
MFGA 208 The World of Electricity and ElectronicsMFGA 221 Instrumentation Devices and Systems MFGA 223 Industrial Electrical Components and Control Devices MFGA 229 Commercial and Industrial Wiring MFGA 226 Motors, Controls and ControllersMFGA 248 Electrical Codes and OrdinancesMFGA 232 Introduction to Programmable Logic Controllers MFGA 261 Introduction to Plant MaintenanceMFGA 376 Mechanical Blue Prints Reading
Work Process
Modesto Junior CollegeTechnical Education Division
435 College Avenue • Modesto, CA 95350
(209) 575-6332
Reading schematics, P&ID diagrams, circuit drawings and operating instructions
Troubleshooting and improvement of electronic control systems
Wiring of control and instrumentation systems
Troubleshooting motors, servo motors, switches, relays, controllers and power supplies
Installing and calibrating control and instrumentation equipment
Installation, calibration and maintenance of level, temperature and flow instrumentation
Reading PLC code, wiring PLC equipment, troubleshooting Allen-Bradley PLC systems, installing, calibrating, and maintaining VFD equipment
Developing and maintaining materials and parts list to support maintenance
Ordering materials and parts necessary for installation and maintenance
Total Hours
Hours
600
1,000
1,000
1,000
1,000
1,000
1,000
1,000
400
8,000
Calibration and Instrumentation Technician