John Deere Mobile RTK Quick Reference GuideSetup Mobile-RTK 1 Select Setup tab.

2 Check SF2 fallback (optional).

3 Select Serial Port tab.

4 Set Baud Rate to “19200”.

5 Set output rate with 1 Hz.

6 Check GGA box.

7 Select “M-RTK” softkey (H).

8 Select “RTCM” or “CMR” correction type.

9 ConfigureM-RTKPort.

10 Set Baud Rate to “19200”.

11 Set Parity to “None”.

12 Set Output Rate(s) to “1”.

13 CheckNMEAMessageGGAbox.

14 Set Data Bits to “8”.

15 Set Stop Bits to “1”.

16 Set Modem Type to “Smart Modem” and enter data from cellular and data correction provider.

NOTE:Pressingthe“Read”button forSignalstrengthwilltime-outtheconnection for up to one minute.

StarFire 3000 - Main SN: 109698

Info Setup Activations Serial Port

StarFire 3000 - Main SN: 123067

StarFire 3000 - StarFire Mobile RTK SN: 391512

Rates

Messages

Info Setup ActivationsSerialPort

StarFire

3D TCM

On

Off

CAL

Correction Mode

Hours On After Shutdown

Correction Type

Corrections Age (s) Data received (kb)

0

Connection duration (hr)

0,0Signal

Strength

System Status M-RTK Correction

RTK Port Configuration

System Status - StarFire 3000 Accuracy (%) GPS Signal (%) SF Signal (dB)

100 100 11,5

RTCM

Mount Direction

Fore/Aft (cm)

180

Baud Rate

GGA

RMC

ZDA

GSA

VTG

Output rate (Hz) 1 5 10

19200

1539,8725

M-RTK

M-RTK Port Configuration

Forward

3

1

20 1

1

819200

None

Height (cm)

282

Use SF2 if RTKSignal Lost

Max CorrectionAge (s)

InitializationTime (min)

Serial Settings andNMEA message

Modem and Network

OutputRate (s)

GGA

Baud Rate

Parity

Data Bits

Stop Bits

Connection Age Limits

RTK RS232 Settings

Configure

Configure

Read

NMEA Message

LastCalibration: Machine

Enable OptimizeShading

Default Correction freq

10:59 pm 11:59 pm

Calibrate10:59 pm

9

1

2

3

4

5

6

7

8

9

10

11

12

13

14

15

16

Copyright © 2012 Deere & Company. All Rights Reserved. THIS MATERIAL IS THE PROPERTY OF DEERE & COMPANY. ALL USE AND OR REPRODUCTION NOT SPECIFICALLY AUTHORIZED BY DEERE & COMPANY IS PROHIBITED.

All information, illustrations, and specifications in this manual are based on the latest information available at the time of publication. The right is reserved to make changes at any time without notice.

PFP12900 (07DEC12)

.....................................

.......................

.....................

...................

Mobile-RTKModemDiagnostic Tractor Cab Installation

1 Modem to be installed in the cab on provided support.

2 Modem Antenna.

3 StarFire 3000 Receiver.

The front of the Mobile RTK Modem is equipped with a yellow LED for status output. It indicates the status of the cellular network and the correction data.

UsetheLEDstatustohelpinquickdiagnosingtheMobileRTKmodem.

Yellow LED

3

1

2