IPV Test ProcedureHow to prepare things before IPV test.How to configure com port to Genex Probe & Mobile Partner.When to plug LTE modem to laptop.When to detach or attach LTE modem.

Open Project that has been saved previously.

Use Auto Detect to configure GPS com port.

After GPS configure, connect to the Probe.When reaching to the Site try to locate where is the Site located at. Observe where are the Antenna facing at. If it cant be seen try to get as near about 200(meters) to start the test.

Always use Auto Detect to configure the Com Port & Modem Port before start doing IPV test.

Filter By Periods only change to 200(ms).

Connect to the Probe.

While idling mode is record, refer to the Maximal to find good RSRP & SINR. Try to get RSRP less than -80(dbm) & SINR more than 26(db).

Import Upload test plan here.Double check make sure FTP address(202.65.247.30) is the same as shown below.Must have 500MB file in the desktop so that easily can locate to make Upload test.

In Network Type; select LTE only.

In Connection Type; select IPV4.

Genex Probe has connected & IDLE mode still recorded.Then while the IDLE mode still recorded, Connect Mobile Partner to the Network.

After Mobile Partner connect to network, observe the Event List message, check weather there is a drop call or not that highlighted in Red.Then, Log file for IDLE mode can be stop.

Detach Mobile PartnerHow to detach Mobile Partner to the network to prevent from drop call & to test next Sector.

Import Detach Only test plan.

Then, make sure disconnect first before start Detach.LTE NETWORK AVAILABLE.

No need to record, click NO.Start Test Plan

LTE NETWORK NOT AVAILABLE.Detach Successful.

Attach Mobile PartnerHow to Attach Mobile Partner to the network to start next Sector test.

Import Attach Only test plan.

LTE NETWORK NOT AVAILABLE.

No need to record, click NO.Start Test Plan

LTE NETWORK AVAILABLE.Attach Successful.

THE END

*