Honeywell Security & Fire 12 Clintonville Rd. Northford, CT. 06472 honeywell.com Configuring the IPGSM-4G to meet FDNY Requirements for Five Minute Fault Annunciation Refer to the IPGSM-4G Installaon and setup guide before performing any programming: 800- 12454V4 AlarmNet 360 Programming: (Works on ﬁrmware version V3.0.7 or later) Verify that the IPGSM-4G firmware version is 3.0.7 or later Log into the AlarmNet 360 website: https://services.alarmnet.com/AlarmNet360/AlarmNetDirect/Acco unt/LogOn (Important Note: NFPA 72 requires installer to be on the job site when programming or making changes to the IPGSM-4G radio configuration) Go to the “Device Programming” page Choose “Program Device” and then choose “Other Communicators” Follow the steps to set up the Customer Account Program the Supervision Interval to “2010 IP & GSM” Click on “Edit” and then click on “Advanced Programming”. Set both the IP fault time and Cellular fault time to 05 (See screenshots below) Click Finish and then exit out of AlarmNet 360 Register the Communicator with AlarmNet Test the IPGSM-4G per NFPA 72 and the local requirements. “Important Note: If 7720P is used to modify programming on the IPGSM-4G aﬅer AlarmNet 360 website programming has been performed the radio will default back to the original factory preset fault mes.” Application Note:

IPGSM-4G_FDNY_Application_Note - Silent knight€¦ · Web viewRefer to the IPGSM-4G Installation and setup guide before performing any programming: 800-12454V4

Download DOCX Report

Upload
others
View
4
Download
0

Embed Size (px)

Citation preview

Page 1: IPGSM-4G_FDNY_Application_Note - Silent knight€¦ · Web viewRefer to the IPGSM-4G Installation and setup guide before performing any programming: 800-12454V4

Honeywell Security & Fire12 Clintonville Rd.Northford, CT. 06472honeywell.com

Configuring the IPGSM-4G to meet FDNY Requirements for Five Minute Fault Annunciation

Refer to the IPGSM-4G Installation and setup guide before performing any programming: 800-12454V4

AlarmNet 360 Programming: (Works on firmware version V3.0.7 or later)

Verify that the IPGSM-4G firmware version is 3.0.7 or later Log into the AlarmNet 360 website:

https://services.alarmnet.com/AlarmNet360/AlarmNetDirect/Account/LogOn(Important Note: NFPA 72 requires installer to be on the job site when programming or making changes to the IPGSM-4G radio configuration)

Go to the “Device Programming” page Choose “Program Device” and then choose “Other Communicators” Follow the steps to set up the Customer Account Program the Supervision Interval to “2010 IP & GSM” Click on “Edit” and then click on “Advanced Programming”. Set both the IP fault

time and Cellular fault time to 05 (See screenshots below) Click Finish and then exit out of AlarmNet 360 Register the Communicator with AlarmNet Test the IPGSM-4G per NFPA 72 and the local requirements.

“Important Note: If 7720P is used to modify programming on the IPGSM-4G after AlarmNet 360 website programming has been performed the radio will default back to the original factory preset fault times.”

Application Note:

https://services.alarmnet.com/AlarmNet360/AlarmNetDirect/Account/LogOn